This is an excellent handbook. We had no information on the appliance until we obtained this and are now able to use the appliance to its full potential. Strongly recommended.
The Owner's manual was very helpful. The WEGA is about 35 years old and needed repair.
Your Website is pretty good und easily to handle.
Thank You
Carl-W. Lohmann
Perfect. Very good service and very good scanning quality. All sheets are very legible. Thank's
Text excerpt from page 6 (click to view)
Channel Setting
This function will automatically tune all local channels for you. The following steps are carried out using the remote control
Initial setting
Auto Tuningtunes in and presets receivable TV stations
Automatically tunes in and presets receivable TV stations
1
MENU CH
Press the main POWER ( ) button on the TV.When you install the TV at first time, it will appears this picture.
AUTO START
TUNING EXIT
2
TV/VIDEO
AUTO TUNING will start when selecting �START�, using CH and CH and pressing on MENU the remote control, or pressing on the TV. All the TV stations in your area that can be received by the TV set are automatically preset between programme position 1 to 99. The screen shows whatever is on programme position 1 when full auto channel preset is finished.
MENU
PR 0 2
AUTO
TUNING
CH 0 2
1 4 7
2 5 8 0
CH
3 6 9
PR 1
CH MENU
NOTE:Make sure to execute AUTO TUNING until tuning is complete. When EXIT has been selected during tuning or when the power has been turned off and then turned on again, the AUTO TUNING screen will be displayed.
After initial setting
Auto tuning
Automatically tunes in and presets receivable TV stations
1
TV
The AUTO TUNING screen will
MENU
AUTO START
TUNING EXIT
appear by holding down on the TV for more than 2 seconds.
2
NOTE
Repeat step 2 above from page 5 (Initial seting)
MENU
AUTO START
TUNING EXIT
� To stop AUTO TUNING, press on the remote control. � When AUTO TUNING is not done, select EXIT by using CH and CH on the remote control
MENU
or press on the TV to return to the TV screen. � Make sure to start AUTO TUNING after connecting the antenna, as the AUTO TUNING screen will be displayed when the power is turned on for the first time. � Make sure to execute AUTO TUNING until tuning is complete. When EXIT has been selected during tuning or when the power has been turned off and then turned on again, the AUTO TUNING screen will be displayed. � When the Child Lock is set, it is not possible to enter the Tuning mode. This is to make sure that Child Lock is not over-ridden by re-tuning the set. (To cancel Child Lock please refer to page 19.)
