|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Hi, thankyou for providing the Nordmende Globetrotter original manufacturer's repair manual. Quality is very good and sharp - the PDF file was comfortably small to download. The only question is: why did it take so long to become ready for download?? Many thanks anyway, I fixed the fault in the radio thanks to the circuit.
regards: Nick
 ;
This was super service.Ordered this manual and was reading the download an hour later
;
as always, rapid and efficient, very good and clear prints
details clearly visible keep going this way!!!!!!
;
I expect a wonderful result as alaways!!!!!!
Usually is much faster....
;
Wow very wonderful and clear!!!! I will always trust them
21J-FV1RU
No. 9 Adjustment point COLOUR SYSTEM Adjustment procedure/conditions 1) Receive the "PAL COLOUR BAR" signal, press MENU, choose CH-SETTING to select COLOR modes except PAL, check the COLOUR is not working properly. Then, select the "PAL" mode. Check again its colour so that it is working properly. 2) Receive "SECAM COLOUR BAR" signal, press MENU, choose CH-SETTING to select COLOR modes except SECAM, check the COLOUR is not working properly. Then, select the "SECAM" mode. Check again its colour so that it is working properly. 3) Receive "NTSC 4.43" signal, press MENU, choose CH-SETTING to select COLOR modes except N443, check the COLOUR is not working properly. Then, select the N443 mode. Check again its colour so that it is working properly. 4) Receive "NTSC 3.58" signal, press MENU, choose CH-SETTING to select COLOR modes except N358, check the COLOUR is not working properly. Then, select the N358 mode. Check again its colour so that it is working properly. 10 SURROUND 1) Receive "music" sound signal. 2) Set MENU, then go into SOUND MENU to select SURROUND. 3) Press VOLUME UP/DOWN key to check SURROUND I, II and OFF effect. 1) Receive "music" sound signal. 2) Set MENU, then go into SOUND MENU to select TREBLE. 3) Press VOLUME UP/DOWN key to check whether the TREBLE effect is OK or not. 1) Receive "music" sound signal. 2) Set MENU, then go into SOUND MENU to select BASS. 3) Press VOLUME UP/DOWN key to check whether the BASS effect is OK or not. 1) Receive mono-tone signal. 2) Set MENU, then go into SOUND MENU to select BALANCE. 3) Press VOLUME UP/DOWN key to check whether the left to right BALANCE effect is OK or not. 1) Receive "PAL COLOUR BAR" signal. 2) Turn up the volume control to maximum, make sure the sound is heard from the speakers. Then put the unit in no signal state. 3) Check the sound mute is effective. 4) Finally turn sound level of CTV to minimum. Waveform and others
11
TREBLE
12
BASS
13
BALANCE
14
NOISE MUTE CHECKING
3 � 24
|
|
|
> |
|
