|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
I found this service manual to be complete in every detail except for troubleshooting charts. It would be helpful if it had a set of troubleshooting charts; however it is a very good manual otherwise and for the price it is very well worth it.
 ;
Complete manual included schematics layouts and alignment procedure, clear to read and magnify, extremely pleased with manual and owner manual . com's service
 ;
perfect, i am very satisfait for the réception of the sansui r-5l service manual, thank you very much
 ;
Thank you, this is a rare document. Few others have it, but they charge way more for a download.
Great deal (even if you have to wait a few hours to get it).
 ;
The purchased manual is an high quality scan of the original Philips paper-based Service Manual. I am very satisfied!
ELECTRICAL ADJUSTMENTS
2-11: VERTICAL SIZE 1. Receive the monoscope pattern. 2. Using the remote control, set the brightness and contrast to normal position. 3. Activate the adjustment mode display of Fig. 2-1 and press the channel button (1) on the remote control to select "H/V". The Fig. 2-6 appears on the display. 4. Press the channel button (3) on the remote control to select "V. SIZE". 5. Press the VOL. UP/DOWN button on the remote control until the SHIFT quantity of the OVER SCAN on upside and downside becomes 8 ± 3%. 2-12: VERTICAL LINEALITY 1. Receive the monoscope pattern. 2. Using the remote control, set the brightness and contrast to normal position. 3. Activate the adjustment mode display of Fig. 2-1 and press the channel button (1) on the remote control to select "H/V". The Fig. 2-6 appears on the display. 4. Press the channel button (5) on the remote control to select "V. LIN 50/60". 5. Press the VOL. UP/DOWN button on the remote control until the SHIFT quantity of the OVER SCAN on upside and downside becomes minimum. 6. Receive the monoscope pattern. (Audio Video Input) 7. Press the AV button on the remote control to set to the AV mode. Then perform the above adjustments 2~5. 2-13: OSD HORIZONTAL 1. Using the remote control, set the brightness and contrast to normal position. 2. Activate the adjustment mode display of Fig. 2-1 and press the channel button (5) on the remote control to select "OTHERS". The Fig. 2-2 appears on the display. 3. Press the channel button (5) on the remote control to select "OSD H". 4. Press the VOL. UP/DOWN button on the remote control until the difference of A and B becomes minimum. (Refer to Fig. 2-7) 2-15: CONSTANT VOLTAGE 1. Using the remote control, set the brightness and contrast to normal position. 2. Connect the digital voltmeter to TP501. 3. Set condition is AV MODE without signal. 4. Adjust the VR501 until the DC voltage is 135 ± 1V. 2-14: TINT 1. Receive the color bar pattern.(Audio Video lnput) 2. Connect the oscilloscope to TP801. 3. Activate the adjustment mode display of Fig. 2-1 and press the channel button (4) on the remote control to select "PICTURE". The Fig. 2-4 appears on the display. 4. Press the channel button (4) on the remote control to select "TINT". 5. Press the VOL. UP/DOWN button on the remote control until the waveform becomes as shown in Fig. 2-8.
"TINT" Fig. 2-8
[ TV ]
OSD H
A
B
Fig. 2-7
D1-3
|
|
 |
> |
|