|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Very good copy of Manual, clear and easy to print off, arrived very promptly and reasonably priced.
Thanks, I will use you again.
;
Zeer duidelijke afdrukken op A4-formaat , zeer uitgebreide handleiding . Pluspunt ,zeer snelle
respons van jullie , binnen de 24h . Top !!!
;
I AM HIGHLY IMPRESSED BY THE EASE OF USE OF THIS DOWNLOAD SERVICE. INSTRUCTIONS ARE CLEAR AND SIMPLE TO FOLLOW....EVEN BY TECHNOPHOBES SUCH AS MYSELF. THE EMAILS POINT YOU IN THE RIGHT DIRECTION...ITS SO EASY PEASY. THE DOWNLOAD CHOICE OF USER MANUALS IS EXTENSIVE AND I COULD NOT FIND A CHEAPER OR MORE EFFICIENT SERVICE ON THE INTERNET. I COULD NOT HAVE MADE A BETTER CHOICE OF INFORMATION PROVIDER. SHOULD I EVER NEED ANOTHER USER MANUAL, THEN THIS IS THE FIRST CHOICE SITE. COULD NOT BE BETTER PLEASED!!!!!!!...MANY THANXES FROM JIM BURNS
;
I was impressed with the quality of service (frequent e-mails to let you know the status of your order), and the speed at which the download became available. The manual was a life saver and was not easy to track down. Thank you for such an excellent service.
;
the manual was just what i wanted it had all the revelent information required to operate the hifi .Iwould use any manual i downloaded for any item which needs a manual
ASSEMBLY
Fitting the loop handle
(325Cx)
Assembling and dismantling the two-piece shaft
(323LD, 325LDx)
�
Position the handle on the shaft. Note that the handle must be mounted below the arrow on the shaft.
Assembly:
� Make sure the knob is loose.
� �
Fit the screw, securing plate and wing nut as shown in the diagram. Tighten the wing nut. � Align the cut-out in the lower part of the shaft with the coupling locking tab on the upper part of the shaft. Then lock the sections together. Tighten the knob.
Fitting the loop handle
(323L, 323LD, 325Lx, 325LDx)
�
�
Clip the loop handle onto the shaft. Note that the loop handle must be �tted between the arrows on the shaft.
Dismantling:
� Undo the knob (at least three turns).
� �
Slide the spacer into the slot in the loop handle. 323L/323LD: Fit the nut, washer and screw. 325Lx/325LDx: Fit the nut, knob and screw. Do not overtighten.
� � �
Push the knob towards the coupling. Carefully twist the lower half of the shaft to unlock it. Hold both parts of the shaft and pull the lower part of the shaft out of the coupling.
�
Now adjust the trimmer to give a comfortable working position. Tighten the bolt/knob.
10 � English
|
|
|
> |
|
