This was a hard to find manual. When I did find it , some sites wanted way too much for the file.
Owner-manual .com had it for a really reasonable price. Not only that but it was sent very quickly and was a quality scanned document, unlike some others I purchased from a different site.
Good job guys!!
Larry
Fast and courteous service. Product delivered as described. Thank you.
Text excerpt from page 13 (click to view)
INSTALLATION
10) INSTALLING THE HOT PLATE WITH THE BATTERY
Check that the appliance is in a good condition after having removed the outer packaging and internal wrappings from around the various loose parts. In case of doubt, do not use the appliance and contact qualified personnel. Never leave the packaging materials (cardboard, bags, polystyrene foam, nails, etc.) within children�s reach since they could become potential sources of danger. The measurements of the opening made in the top of the modular cabinet and into which the hot plate will be installed are indicated in either fig. 9/A and 9/B. Always comply with the measurements given for the hole into which the appliance will be recessed (see fig.9/A � 9/B and 10). The appliance belongs to class 3 and is therefore subject to all the provisions established by the provisions governing such appliances.
11) FIXING THE HOT PLATE
The hot plate has a special seal which prevents liquid from infiltrating into the cabinet. Strictly comply with the following instructions in order to correctly apply this seal: - Detach the seals from their backing, checking that the transparent protection still adheres to the seal itself. - Overturn the hot plate and correctly position seal �E� (fig. 11) under the edge of the hot plate itself, so that the outer side of the seal perfectly matches the outer perimetral edge of the hot plate. The ends of the strips must fit together without overlapping. - Unscrew the ignition cap �T� (see fig. 14) and fit a 1,5 V battery (not included in the appliance) with the positive �+� polarity turn inside. Rescrew the cap. - Evenly and securely fix the seal to the hot plate, pressing it in place with the fingers. - Fix the hob with the proper brackets �S� and fit the prominent part into the porthole �H� on the bottom; turn the screw �F� until the bracket �S� stick on the top (fig. 12).
