|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
This manual covers the main equipment features only. While it also includes the procedure for saving and loading from the now long obsolete memory cards it does not mention the how to operate with the optional floppy drive interface so I am still at a loss about how to use this! Note that there is a separate manual covering the MIDI interface and programming via the keyboard, not included in this download. You will also need to get hold of this if you want to use the MIDI interface properly. Basically there is little difference between this manual and the free to download manual for the similar PR60 model.
;
Good list of manuals. I found a very rare one and easily get. Should be promptly to download, as we must to wait hours even after confirmed payment.
;
The manual was properly scanned and perfectly readable. The only small problem is that I couldn't use my dear Ctrl + F to find a word I needed.
;
Nothing wrong with the manual or the delivery - came to me the same day I ordered it. But afterwards I realized that I ordered the wrong manual. Probably better with the Quick start - version. So maybe it would be better if we could see a list with inhold for each manual before ordering?
 ;
Bought T4850 High End Tuner a few years ago, but i didn't know where all the buttons were used for. So i purchased the owners manual. Perfect! Just what i needed.
SAFETY INSTRUCTIONS
C General advice on setting raker clearance
� When you sharpen the cutting teeth you reduce the RAKER CLEARANCE (cutting depth). To maintain cutting performance you must file back the raker teeth to the recommended height. See the �Technical data� section to find the raker clearance for your saw chain. � On a low-kickback cutting link the front edge of the raker lip is rounded. It is very important that you maintain this radius or bevel when you adjust the raker clearance. � We recommend the use of a raker gauge to achieve the correct clearance and bevel on the raker lip.
D Setting the raker clearance
� Before setting the raker clearance the cutting teeth should be newly sharpened. We recommend that you adjust the raker clearance every third time you sharpen the chain. NOTE! This recommendation assumes that the length of the cutting teeth is not reduced excessively. � To adjust the raker clearance you will need a FLAT FILE and a RAKER GAUGE.
� Place the gauge over the raker lip.
� Place the file over the part of the lip that protrudes through the gauge and file off the excess. The clearance is correct when you no longer feel any resistance as you draw the file over the gauge.
The risk of kickback is increased if the raker clearance is too large!
3 Tensioning the chain
A slack chain may jump off and cause serious or even fatal injury. � The more you use a chain the longer it becomes. It is therefore important to adjust the chain regularly to take up the slack. � Check the chain tension every time you refuel. NOTE! A new saw chain has a running-in period during which you should check the tension more frequently. � Tension the chain as tightly as possible, but not so tight that you cannot pull it round freely by hand.
English �
13
|
|
|
> |
|
