|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
The TEAC A-1500's Service Manual was instrumental in reviving this classic reel-to-reel. Not only does it have the schematics, exploded parts diagram and parts list, it also provided mechanical adjustment information that approximate factory default settings.
 ;
This service manual was determinant to enable to fix my Alpine Amplifier. I am pleased with my purchase. For a 5 star rating I would like to see a higher resolution scan of the printed circuit board lay-out because the gray scale grafics was dificult to see. Also some schematic diagrams were scanned at a slight angle. Never the less, it had all information I needed to troubleshoot and service my equipment.
;
Complete manual, the good quality of reproduction allows enlarged print-out of the schematic diagram in the size it probably had in the original print edition and which is necessary for practical use.
;
The service manual was complete and the components on the drawings very good visible.
;
downloaded next day , manual is very helpful , fast and easy
TE430VX SPECIFICATION UPDATE
DOCUMENTATION CHANGES
The Documentation Changes listed in this section apply to the TE430VX Motherboard Technical Product Specification (Order Number 281817). All Documentation Changes will be incorporated into a future version of the appropriate TE430VX motherboard documentation.
1.
Revision of Section 1.11.3, Wavetable Connector
This second paragraph in this section will be replaced in its entirety as follows: Compatible wavetable cards are available from several vendors.
2.
Revision of Section 5.2, Specifications
The following note will be added to the table entry for PCI compliance:
NOTE: Certain optional PCI features have not been implemented on this motherboard, see section 1.14 for more information.
3.
�
Revision of Section 1.7.1, 82437VX Xcelerated Controller (VXC)
Fully synchronous PCI bus interface    25/30/33 MHz PCI to DRAM data transfers up to or greater than 100 MB/sec Up to 4 PCI masters in addition to the PIIX3
The fourth bullet in this section will be replaced in its entirety as follows:
4.
Revision of Section 1.12.4, Add-In Board Expansion Connectors
The text in the first paragraph of this section will be replaced in its entirety as follows: The motherboard Expansion Slots support up to four bus mastering PCI and up to three ISA add-in boards. One of the PCI slots may be shared with an ISA slot.
5.
Revision of Section 1.13.3, Clear CMOS (J9C1-A)
This section will be replaced in its entirety as follows: Allows CMOS settings to be reset to default values by moving the jumper from pins 4-5 to pins 5-6 and turning the system on. When the system reports that �NVRAM cleared by jumper�, the system can be turned off, and the jumper should be returned to the 4-5 position to restore normal operation. Default is for this jumper to be on pins 4-5. Caution: This procedure should only be done if, after a BIOS update, the system does not boot to a point where BIOS Setup can be entered or if, after CMOS default settings have been restored from within the Setup program, the system does not boot to the operating system.
14
|
|
|
> |
|
