|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
I didn't realise a manual for an early plasma TV such as the one we were gifted could be so easily obtained. No manual was supplied with it, and as senior citizens we were a little puzzled over some aspects of its use. I do not want a listing for your store credit as we are not fairly big computer users. The manual was well organised, as it should be, with its backing of the Pioneer name. The download was prompt and everything worked quite smoothly. Thank you. Gordon.
;
Thank you very much for the manual. It is what I needed and it will be very helpful to me. The delivery of the manual was easy and very fast. I strongly recommend this site to other users. Best regards.
 ;
Excellent!! Got what I need and very fast!! Thank You
;
Manual acquired with good resolution, complete in all its pages, very good policy of the folder where are saved all products purchased.
;
Service manual very complete and clear. It was very helpfull for my work.
1. ELECTRICAL ADJUSTMENTS
1.1. Supply Voltage Adjustment Connect a digital voltmeter to the cathode of diode D611 at the AV1 mode of the TV and set the screen voltage to the minimum with the screen potentiometer. Adjust the main supply voltage (B+) with P601 potentiometer to the following value (after adjustment, readjust Screen voltage). 21� Pure Flat : 132 VDC 25� : 145 VDC 28� : 145 VDC (147 VDC for A66EAK071X11) 28� Pure Flat 16/9 : 140 VDC 28� Super Flat 16/9 : 140 VDC 29� Pure Flat : 125 VDC 29� Super Flat : 125 VDC 32� Pure Flat 16/9 : 140 VDC 32� Super Flat 16/9 : 131 VDC 33� : 158 VDC
2. SERVICE ADJUSTMENTS
You need the special service remote control to enter and exit the service menu of the TV (you can order it from the manufacturer). All buttons of the Service RC are same with the user remote control, only service menu In / Out is added to it (please see the picture below). Navigation Service In/Out : Enters to / exits from the Service Menu P+ / P: Moves upward / downward inside the menu V+ / V: Changes the values or options
2.1. AGC Adjustment � � � Apply an RF signal with amplitude 70±1 dBuV to the antenna input of TV with a pattern generator (switch sound carrier to Off and switch �Video Ext� to On). Switch on the Service Menu with the Service RC and find the AGC with P+ / P- buttons. Measure the 38.9 MHz signal on pin 11 (IF) of Tuner with an oscilloscope. Adjust �AGC� to get following values: PAL BG, PAL SECAM BG, PAL SECAM BG-DK, PAL I versions : 840 ± 20 mVpp PAL SECAM BG-LL version : 600 ± 20 mVpp PAL BG MONO, PAL SECAM BG MONO : 750 ± 20 mVpp PAL I MONO : 900 ± 20 mVpp Substract 5 from �AGC� value and change �TEST� to this value. Exit from the service menu with the Service RC.
� �
|
|
|
> |
|
