This is an excellent handbook. We had no information on the appliance until we obtained this and are now able to use the appliance to its full potential. Strongly recommended.
The Owner's manual was very helpful. The WEGA is about 35 years old and needed repair.
Your Website is pretty good und easily to handle.
Thank You
Carl-W. Lohmann
Text excerpt from page 21 (click to view)
Sound level This menu is used to balance the volume between the loudspeakers. æ Select SOUND LEVEL (y key) and press . The SOUND LEVEL menu appears. � Select TEST (y key) and press .A continuous sound is emitted from each channel in turn: left, right, centre and rear channel. ê Use the � q keys to adjust the level of each channel independently: BALANCE, CENTRE and REAR.The sequence stops while the level is being changed and then automatically starts up again. To stop the test : Press the red key. Levels may also be adjusted without using the test signal. Equalizer æ Select EQUALIZER (y key) and press . The EQUALIZER menu appears. � Use the yx keys to select each frequency (from bass: 100 Hz to treble: 10 kHz) ê Use the � q keys to adjust the level. You can view the presets corresponding to the smart sound controls by pressing the key on the remote control. To exit from the menu: Press the red key. Spatial This setting increases the stereo effect giving the impression that the loudspeakers are spaced further apart. Headphones This setting allows the volume of the headphones to be adjusted independently from the TV set. To exit from the menu: Press the red key.
Features menu
You can select CHILDLOCK, STORE PP, TIMERS and CORDLESS (only applicable to some sets) Childlock Set to ON to lock the television keys. Switch off the TV and hide the remote control.The TV cannot now be used (only the remote control will enable you to switch the TV on). To cancel: reset the CHILDLOCK to OFF. Stor e PP This function allows you to store your own picture and sound adjustments. The adjustments are restored every time your set is switched on, or by pressing the key on your remote control. æ First carry out your PICTURE and SOUND adjustments and adjust the volume and then: � Display the FEATURES menu, select STORE PP (y key) and press . The message OK appears. All the PICTURE and SOUND menu adjustments as well as the volume are stored.
