|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Thanks God for the internet and thanks for the service like this - proffessional solution on time.
;
About the service it's very fast and reliable. About the manual the quality is high enough to read even the tiniest details on the wiring diagrams so you can't ask much more than that, let it alone for a manual of a product from 20 years ago. Thank you, very satisfied.
;
The downloaded quality was as good as the orignial
 ;
This is a great and complete Service Manual for the Sharp GF8585HB. Giving full and detailed technical insight. Good to find these manuals online.
;
Everything was ok with the manual. If I have a small complaint, is that I ordered it during the weekend and I think you guys were closed. But I did receive it late Sunday. I will surely order from you again
28JS-74E
Vertical Bow Adjust the Vertical Bow so that the picture is centred. The effect of this adjustment is shown in figure 11. � When the volume up button is pressed, the vertical bow changes to left. � When the volume down button is pressed, the vertical bow changes to right. � Press the stand-by button on the remote control to store. Vertical Amplitude Adjust the Vertical Amplitude so that 8% over-scan is achieved. The effect of this adjustment is shown in figure 12. � When the volume up button is pressed, the vertical size of the picture increases. � When the volume down button is pressed, the vertical size of the picture decreases. � Press the stand-by button on the remote control to store. S Correction Adjust the S Correction so that the picture symmetrical between the top, centre and bottom. The effect of this adjustment is shown in figure 13. � When the volume up button is pressed, the top and bottom scanning decreases and the centre scanning increases. � When the volume down button is pressed the top and bottom scanning increases and the centre scanning decreases. � Press the stand-by button on the remote control to store. Vertical Shift Adjust the Vertical Shift so that the picture is centred. The effect of this adjustment is shown in figure 14. � When the volume up button is pressed, the picture moves up. � When the volume down button is pressed, the picture moves down. � Press the stand-by button on the remote control to store. Figure 14 Colour Adjustments The following adjustments should only be carried out when the CRT or IC801 are replaced. G2, Cut Off and Gain Adjustments 1. Follow the procedure below to set the G2 1.1 Tune the set to the output of a signal generator (cross hatch pattern). 1.2 In the user menu, set contrast to 80/100 and brightness to 40/100. 1.3 Connect the oscilloscope to the TP1801 and adjust G2 to read 135V on the sensor pulse as in the drawing:
135 V
Figure 11
Figure 12
Figure 13
CH1 gnd
10
|
|
|
> |
|
