|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Everything was ok with the manual. If I have a small complaint, is that I ordered it during the weekend and I think you guys were closed. But I did receive it late Sunday. I will surely order from you again
;
Best Service! Very fast and easy to handle. Fast Download an you can come back every day to download again
;
Very good quality, no parts are missing and everthing is readable.
Thank you very much. :-)
;
This manual is all I need to check and repair my equipment. Thank you....
 ;
sorry for my english...the service given by O.M.com is perfect for content and codition...!!!
thank's a lot!!!
best greetings
ADJUSTMENT PRECAUTION
The model is a mixture of the adjustment items of I2C BUS-CONTROL and the existing analog adjustment. Moreover, since the adjustment with I C BUS-CONTROL is composed of the items which are set with the initial values (preset values) alone and the data variable items, refer to the following.
2
!"#$%
!"#$%fO` ! !"#$%&'()"*+#$,-./012345fO` 89:; !"#$ <=>?@ !"#$%&'()*+,-.)/-.01234567012
NF
!"#$%&'()*+,
1 2 3 4 5 pbq=rm oL` oL` oL` pbq=rm !PRN PRO !"# $%&'()*+,-fO` !"#$
1) Setting method to the microprocessor service mode
1 When the jumpers 351 and 352 of SET UP are short-circuited, enter into the service mode (I2C BUS CONTROL adjustment mode). 2 The modes can be sequentially selected with the CH DOWN key of R/C. 3 The modes can be sequentially selected in the reversed order of 2 with the CH UP key of R/C. 4 The data can be converted with the VOLUME UP/DOWN key of R/C. 5 When the short circuit between the jumpers 351 and 352 of the setup is cut off, it will be released from the service mode.
!"E`e=altkF
!"#$%&'()*+,
!"E`e=rmF !"#2 !"#$%&'()* !"L Eslirjb=rmLaltkF !"#$%&' !PRN PRO !" #$%&'()*+,-./
OF
1
!"#$%
&'$%
ElkF bOmolj
!"#$%&'()*+,-./0Ej^fk=mltbo=ptF
2) Initial value (preset value) setting
1 When the MAIN POWER switch set at the service mode side is turned on, the initial value will be automatically set only on the new E2PROM (discriminated with the head 4 bytes). 2 The initial data is set as shown in the attached sheets. 3 Take care that there are the items which need be changed and the items in which the initial values continue set.
2 3
!"#$%&'()*$Q !"#$%&'()*!"+,-./0 !"#$%&'()*+,!"#$%&'()*+,-.&/01()*2345678
5
29A-FX5 29A-FX8
E5
C5
|
|
|
> |
|
