|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
This manual provided the necessary information to properly use the C-3 deck. The manual was an excellent reproduction and very clear.
;
Product was very good. Received quickly and complete
 ;
Although printing quality is not the best, the manual was very helpful in order to reactivate this ancient but still good electronic musical instrument.
;
as a first-time user and buyer from this site, i found the overall service outstanding!! this product is a godsend as, without it, i would never have been able to find my way around and use my machine as intended. i will certainly use this site again as required. many many thanx!!
;
This manual is exactly what I needed. This site always has every manual I need, and it is also much less expensive then most other sites. This is the only manual site I will use.
Connect the inlet hoses to the washer
A B
Check for leaks
Turn on the water faucets and check for leaks. A small amount of water might enter the washer. You will drain this later. NOTE: Replace inlet hoses after 5 years of use to reduce the risk of hose failure. Record hose installation or replacement dates for future reference. â� If you connect only one water hose, you must cap off the remaining water inlet port.
â�
Periodically inspect and replace hoses if bulges, kinks, cuts, wear, or leaks are found.
Secure the Drain Hose
1. Remove the shipping material from the power cord. Drape the power cord over the console. 2. Remove any cardboard used to move washer.
A. Cold water inlet valve B. Hot water inlet valve
1. Attach the hot water hose to the bottom inlet valve. 2. Attaching the hot water coupling first makes it easier to tighten connection with pliers. 3. Screw on coupling by hand until it is seated on the washer.
Beaded tie strap
3. Wrap the drain hose to the laundry tub leg, drain standpipe or inlet hoses, with the beaded tie strap. Push fastener into the nearest hole in the beaded tie strap. See view A or B.
4. Using pliers, tighten the couplings with an additional two-thirds turn. NOTE: Do not overtighten or use tape or sealants on the valve. Damage to the valves can result.
A
B
C
If the washer faucets and the drain standpipe are recessed, put the formed end of the drain hose into the standpipe. Tightly wrap the tie strap around the water inlet hoses and the drain hose. See view C.
5. Attach the cold water hose to the top inlet valve. 6. Screw on coupling by hand until it is seated on the washer. 7. Using pliers, tighten the couplings with an additional two-thirds turn. NOTE: Do not overtighten or use tape or sealants on the valve. Damage to the valves can result.
10
|
|
|
> |
|
