|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Genuine Toshiba owner's manual. Couldn't really ask for more. And written in understandable English in contrast to a few recent experiences I have had with manuals for other equipment other than Toshiba but made in China and written in "Chinglish"!
;
I purchased a vintage Sony mixer off eBay and within the hour was able to locate and purchase the manual for it.I mean really,where else can you find a manual for a product made in 1983!? It was easy to find and purchase/download the manual I needed.I will use this site again for other equipment I have! Great site!
;
manual de usuario perfecto y completo de buena calidad de impresion y muy detallado ideal !
 ;
It`s full copy of a service manual from url http://www.philips.owner-manuals.com/PM3216-service-manual-PHILIPS.html
;
perfect! you just sent to me the copy in Italian witout even my specification!!!! so you are really smart cooperative and efficient. To my opinion the best place all over to get a manual of electronics!!!!
ASSEMBLY
Assembling the loop handlebar
� Position the handle on the shaft. Note that the handle must be mounted below the arrow on the shaft. � Fit the bolt, securing plate and wing nut as shown in the diagram. � Tighten the wing nut. 2.
Assembling the blade
Fit the blade as follows: 1. Fit the drive disc (A) on the outgoing shaft. Make sure that the edge that �ts in the hole of the blade is facing outward. Block the blade rotation by inserting locking pin in the hole behind the blade guard engaging it in the corresponding hole in the drive disc. Fit the blade (B) on the drive disc. Fit the support �ange (C). The support �ange must be �tted with its outer edge hard up against the blade. Fit the locknut (D). NOTE! The locknut has left-hand threads. The tightening torque of the locknut is 35 � 50 Nm. Remove the locking pin.
3. 4.
5.
6.
Assembling the angle gear
� Assemble the angle gear back on the supporting tube. Turn the blade so that the drive shaft engages in the angle gear.
NOTE! Do not forget to remove the locking pin before using the machine.
!
WARNING! Under no circumstances may the edge cutter blade be used without the blade guard �tted.
� Position the angle gear so that its slot is aligned with the line on the supporting tube.
� Firmly tighten the screw.
English �
13
|
|
|
> |
|
