|
Who's Online
There currently are 6043 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
Although printing quality is not the best, the manual was very helpful in order to reactivate this ancient but still good electronic musical instrument.
;
as a first-time user and buyer from this site, i found the overall service outstanding!! this product is a godsend as, without it, i would never have been able to find my way around and use my machine as intended. i will certainly use this site again as required. many many thanx!!
;
This manual is exactly what I needed. This site always has every manual I need, and it is also much less expensive then most other sites. This is the only manual site I will use.
;
Useful manual, good scan, worth the pay if you find the unit difficult to operate.
;
Exactly as described, the full user-manual (145 pages). Perfect.
ASSEMBLY
Fitting the hand guard and loop handle
(325HDA55,323HE3,325HE3) It is important that the hedge trimmer is laid on a �at surface when you �t the cutting head. Otherwise the cutting head may not be �tted straight. 1 Fit the cutting head to the shaft. CAUTION! Make sure the drive shaft inside the shaft engages with the recess in the cutting head.
Fitting the cutting head
(325HDA55, 323HE3)
1
Assemble the hand guard and loop handle by screwing them together. Take care to align the holes in both parts. (325HDA55, 323HE3)
2 3 4
Slide the loop handle and hand guard onto the shaft. (325HDA55, 323HE3) Slide the spacer into the slot in the loop handle. Fit the nut and screw. Do not overtighten. 2 Tighten the lower screw �rst, then the upper screw.
Adjusting the harness
(325HE4)
5
Now make a �nal adjustment to give yourself a comfortable working position. Tighten the screw. CAUTION! The loop handle and hand guard must not be �tted behind the arrow marked on the shaft.
You should always use the harness with the machine to give maximum control over the machine and reduce the risk of fatigue in your arms and back. 1 2 3 Put on the harness. Hook the machine onto the harness support hook. Adjust the length of the harness so that the support hook is roughly level with your right hip.
Fitting the handle
(323HE3, 325HE3,325HE4)
Fit the handle using two screws.
10 � English
|
|
|
> |
|