|
Who's Online
There currently are 6043 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
Excellent service from this company (including a total refund on an earlier purchase when through no fault of the company the manual was incomplete). I have purchased several manuals which I have been very satisfied with, as I am with this one. Highly recommended.
;
It was easy to order and received exactly what I needed. Only complaint would be the 24 hours you have to wait.
;
Manual was delivered in a timely manner and was all in English as advertised. The manuals I received when we moved into our flat were in German, Italian, and French. Having never used a steamer before, and not speaking/reading German very well, I needed an English Manual. this was a huge help.
;
Great Manual. This manual is available no where else. It was exactly what I was looking for. Only in German.
;
This GRUNDIG UV5A Owner Manual is not only an instruction manual but a total functional circuit description of the Multimeter and includes circuit diagram at the end pages. It is very helpful for repairing and calibrating the instrument. It is written in two languages English and German for international support. It was very easy to repair my unit with this document. Regards, Regis Pauly, Electrical Engineer.
ASSEMBLY
Fitting the loop handle
(325Cx)
Assembling and dismantling the two-piece shaft
(323LD, 325LDx)
�
Position the handle on the shaft. Note that the handle must be mounted below the arrow on the shaft.
Assembly:
� Make sure the knob is loose.
� �
Fit the screw, securing plate and wing nut as shown in the diagram. Tighten the wing nut. � Align the cut-out in the lower part of the shaft with the coupling locking tab on the upper part of the shaft. Then lock the sections together. Tighten the knob.
Fitting the loop handle
(323L, 323LD, 325Lx, 325LDx)
�
�
Clip the loop handle onto the shaft. Note that the loop handle must be �tted between the arrows on the shaft.
Dismantling:
� Undo the knob (at least three turns).
� �
Slide the spacer into the slot in the loop handle. 323L/323LD: Fit the nut, washer and screw. 325Lx/325LDx: Fit the nut, knob and screw. Do not overtighten.
� � �
Push the knob towards the coupling. Carefully twist the lower half of the shaft to unlock it. Hold both parts of the shaft and pull the lower part of the shaft out of the coupling.
�
Now adjust the trimmer to give a comfortable working position. Tighten the bolt/knob.
10 � English
|
|
|
> |
|