|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
I found the manual to be clear concise and complete. It was of immense assistance when removing the unit as the unit was over 22 years old and the wiring diagram was unobtainable from the manufacturer. The exploded drawings were clear as were the instructions and labels.
;
I will highly recommend this seller. They are honest, accurate, fast and responsible.
;
This manual was very good & was very helpful with repairs.
Always great & fast service from Owner's manual.
;
Very pleased with the quality of the scan. No complaints whatsoever.
 ;
I liked the product. I would use their sevices again.
ITEM HORIZONTAL POSITION (HPOS) VERTICAL POSITION (VPOS)
ADJUSTMENT PROCEDURE 1. Call up the adjustment mode display, then select the item HPOS or VPOS. 2. Press the TV/VIDEO button on Remote until the white cross-bar or black cross-bar pattern appears on the screen. 3. Adjust the HORIZONTAL and VERTICAL position alternately by pressing the VOLUME s or t button for proper picture position. 4. Check the picture with off-air signal. 1. Call up the adjustment mode display, then select the item HIT. 2. Press the VOLUME s or t button to get the picture so the top of raster begins to lack. 3. Press the VOLUME s button to advance the data by 9 steps. Note : Check the vertical picture position is correct. 1. Adjust the CONTRAST control to the center, and BRIGHTNESS control to the maximum. 2. Call up the adjustment mode display, and press the TV/VIDEO button on Remote until the white and black pattern appears on the screen. 3. Adjust the following item with the CHANNEL s/t and VOLUME s/t buttons.
RCUT GCUT BCUT Data : 40H Data : 40H Data : 40H GDRV BDRV Data : 40H Data : 40H
HEIGHT (HIT)
WHITE BALANCE (RCUT) (GCUT) (BCUT) (GDRV) (BDRV)
4. Press the TV/VIDEO button on TV to display a single horizontal line on the screen. 5. Turn the SCREEN control (FBT) fully counterclockwise and gradually rotate clockwise until the first horizontal line appears slightly on the screen. 6. Press the TV/VIDEO button to display the normal picture. 7. Adjust the remaining two �?CUT� items (CHANNEL s/t � TV/VIDEO � VOLUME s/t in order) to obtain the slightly lighted horizontal line in the same levels of three (red, green, blue) colors. The line should be white if the adjustments are proper.
Bright area Adjust "GDRV" or "BDRV" to be white. Dark area Fine adjust "RCUT", "GCUT" or "BCUT" to be black.
PIP SUB-BRIGHTNESS (PBOF) PIP WHITE BALANCE (PGOF, PROF) PIP SUB-TINT (PHUE) Adjust to match the PIP screen to the brightness, white balance and tint of the main picture.
� 13 �
SPECIFIC INFORMATIONS GENERAL ADJUSTMENTS
|
|
|
> |
|
