|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
I really like this manual and it's reliable.I found and bought easly.thank you.
;
Thank you very much. the Instruction corresponds to my expectations. Sent it in time. I don't regret that paid money.
;
Good quality. Quick service. I recommend to everyone.
;
Very good quality scan of the document. I am very pleased with what I got.
;
PDF Contains
Technical Data, Mechanical data, Detailed Circuit diagram with components value, PCB layout. Actual PCBs Print. Component List, Spare parts code list and Input output detail. It cover LBB1211, LBB1212, LBB1213, LBB1216, LBB1217.
It is the actual Service Manual for SQ10
32JW-73E
DVCO Adjustment (PAL) Carry out the DVCO Adjustment (PAL) as shown below: 1. Receive a Philips pattern signal. 2. While in the DVCO ADJUSTMENT (PAL) menu, press the stand-by button. 3. The adjustment will be carried out automatically and stored. DVCO Adjustment (NTSC) No adjustment required. AGC Adjustment (B/G) To correctly align the �B/G� Automatic Gain Control, follow the procedure outlined below: 1. Tune the set into a pattern generator on CH E12 (B/G). 2. Adjust the signal strength of the pattern generator to 59dB/mV (75W). 3. Enter the Service Mode. 4. Enter the AGC Adjustment menu (although it only appears on screen �AGC Adjustment� you are in the �B/G� one). 5. Press the stand-by button on the remote control. 6. The adjustment will be carried out and stored automatically. AGC Adjustment (L) To correctly align the �L� Automatic Gain Control, follow the procedure outlined below: 1. Tune the set into a pattern generator on CH F10 (L). 2. Adjust the signal strength of the pattern generator to 59dB/mV (75W). 3. Enter the Service Mode. 4. Enter the AGC Adjustment menu (although it only appears on screen �AGC Adjustment� you are in the �L� one). 5. Press the stand-by button on the remote control. 6. The adjustment will be carried out and stored automatically. Auto Installation On/Off To return the receiver to the original Auto Installation mode, using the volume up or down button, set the Auto Installation On/Off to On. This setting is automatically stored and when the receiver is turned on the next time it will start up in Auto Installation mode.
LED FLASHING CODES
If the TV set does not work and the power indicator is flashing, follow the sequence according to the information below, as a guide to fault finding. 1. Unable to read or write into NVM: 66% ON, 33% OFF twice and OFF for a second.
On Off
2. MSP failure: 66% ON, 33% OFF for three times and OFF for a second.
On Off
3. VCT failure: 66% ON, 33% OFF for four times and OFF for a second.
On Off
12
|
|
|
> |
|
