|
There are currently no product reviews.
 ;
Great Job even clear than the one before!!!! god organization- I'm always very satisfied
;
I'm very happy that you all are performing an incredible good job. Furthermore what you did is very useful for all people as me that have electronics as an hobby.Thank you!!!!!
;
Manual found fast and good quality, very helpfull service
;
8-17-12 Been using the sight for about 6 months. Fast Downloads and top quality
Manuels !
 ;
Everything was great, the manual, the response time, the simplicity of the order, and the
Price. The only thing that I could possible say on a negative note would be that the manual I ordered was more for a service tech. There were a lot of schematic diagrams that didn't help me solve the problem. However I would order again and recommend the web sight to others.
32LD7200 (PW2L)
6. Adjustment
� How to get to Adjustment mode Using the center of the upper control buttons with the set turned off (standby) can activate it. Press the SUB-POWER( ) button, INPUT SELECT( more than 5 seconds. The set turns on in adjustment mode with OSD. � Changing data and Selecting Adjustment code When the set is in adjustment mode, the cursor buttons may be used as the adjustment keys. , , buttons are used for changing data values. OK button is used for confirming the data. After finishing the necessary adjustment press MENU button. Adjustment mode is released and the set returns to normal condition. � Memory Initialize operation NOTE: The execution of this function returns the adjustment codes to the preset values, therefore, adjustment data will be lost. Procedure (1) Enter Adjustment Mode. (2) Select MEMORY INIT adjustment code (No.658) and change the data value from 0 to 1. (3) Activate MEMORY INIT by pressing OK button for more than 3 seconds. (4) Select No.525 and change data value from 1 to 0. (5) Check that the receiving channel goes to P1. Unit is set to preset values. , , , and OK buttons of the remote control or the control ) button and button at the same time, and hold for
buttons are used for selecting adjustment code.
10
|
