This is an excellent handbook. We had no information on the appliance until we obtained this and are now able to use the appliance to its full potential. Strongly recommended.
The Owner's manual was very helpful. The WEGA is about 35 years old and needed repair.
Your Website is pretty good und easily to handle.
Thank You
Carl-W. Lohmann
My first manual from Owner-Manuals.com but not the last! I am very satisfied with the easy ordering and promt delivery of a manual I did not find anywhere else.
Text excerpt from page 65 (click to view)
42 inch
4. Fasten the wall-mount unit securely to the wall. G Clamp to two or more of the long slotted holes in the upper and lower parts of each wall-mounting metal in a well-balanced manner.
cutout
5. Dressing the cables G When passing the plasma TV power cord and signal cables behind the plasma TV, use wire clamps, etc., to prevent cable damage.
Mount on a firm, solid surface. Wall-mount metal (top)
Wall-mount metal (bottom) Use the washers provided as necessary.
Wire clamps
Mounting the TV-mount metals on the plasma TV
1. Remove the stand. x Place a protective sheet cover on the top of a table and place the plasma TV on the cover with the back side upward. � Remove the 4 EMI ground screws. (for CL32-PD2100 only.) � Remove the 4 or 5 (CL37-PD2100) screws fastening the stand and remove the stand in the direction indicated by the arrow mark.
Remove the 4 screws Remove the 4 EMI ground screws.(CL32-PD2100)
2. Installing the TV-mount metals
CL32-PD2100
IFasten the two TV-mount metals to the back of the
plasma TV with 4 M6 x 18 screws.
4 M6 x 18 screws TV-mount metal
Plasma TV
The 3rd TV-mount metal hole
Remove the screws (CL37-PD2100)
Table Stand Protective sheet cover
The 4th TV-mount metal hole