|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Superb! It's the original manual. We can now use our old calculator with its full function.
;
This is a very well written and comprehensive manual. It answered all our queries.
;
Excellent copy that was delivered within 12 hours and solved my problem.
 ;
I did not have the manual for a Whirl Pool gas dryer, therefore I purchased it from Owner-manuals. This is exactly what I needed. Thank you for the service.
;
I was so pleased to get the owner`s manuel within one hour! Thanks again.
Regards
Werner
Quick installation
The first time you switch on the television, a menu appears on the screen and the tuning starts automatically.
Main � Install � Auto Store � Searching Please Wait Prog. found 3 525,25 MHz
shows the progress of the search and the number of programs found. At the end of the search, the menu disappears. To exit or interrupt the search, press H. If no program is found, consult the possible solutions p. 12. & If the transmitter or cable network sends the automatic sort signal, the programs will be numbered correctly. In this case, the installation is complete. é If this is not the case, you need to use the Sort menu to number the programs correctly. Some transmitters or cable networks broadcast their own sort parameters (region, language, etc.). In this case, indicate your choice using the <> keys and validate with �.
If the menu is not displayed, press and hold down the �- and �+ keys on the TV set for 5 seconds to start the tuning. All the available TV programs will be stored. This operation takes a few minutes.The display
Program sort
& Press key H.The Main menu is displayed on the screen.
Main � Install � Language Country Auto Store Manuel Store Sort Program � � � � � � 00 01 BBC1 02 BBC2 03 � ANGLI 04 CH4 05 CH5
é With the cursor, select the Install menu followed by the Sort menu. � Select the programme you want to move using the <> cursor and press �. � Then use the <> cursor to select the new number and validate with �. ( Repeat steps � and � for each program you wish to renumber. § To quit the menus, press d.
Name �
Program name
If required, you can give a name to the programmes and external connectors. Note : on installation, the programs are named automatically when an identification signal is sent. & Press the H key. é With the cursor, select the Install menu, then
Name.
� Use the @ P # keys to select the programme to name or rename.
� Use the �� cursor to move around the name display area (5 characters) and the <> cursor to select the characters. ( When the name has been entered, use the H cursor to exit.The name is stored. § Repeat steps � to ( for each programme you wish to name. è To quit the menus, press d.
4
|
|
|
> |
|
