|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Great manual, great price. I am very pleased with Owner-Manuals.com, quick service, fast communication. Will definitely use this site again.
;
Hello from Germany - thank you very much for the manual for my Sharp "Searcher" - the handling of your internet area is outstanding..Mike
;
I am very happy with the owner's manual. I bought a used Casio and was so relieved that I was able to get a hold of a owner's manual. It was very easy to download the manual and I had no problems with printing it. Thank you! Nancy Whalen
;
The purchased manual is an high-quality scan of the original JVC paper-based Owner´s Manual. I am very satisfied!
;
Very satisfied with received document, all is right, Thank You very much, it was a Pleasure to work with You.
Connect Extra loudspeakers / Amplifier
REAR multimedia loudspeakers You can enjoy Dolby Pro Logic Surround sound by connecting two rear loudspeakers to be connected or to the connector clips (if provided) or to the Dolby Surround output S at the back of your TV. To the connector clips (if provided)
or
To the output S
AUDIO S
R
L
REAR
&
Connect two Surround Sound rear loudspeakers (min. 16 �) to the connector clips at the back of the TV. Always connect both Surround Sound loudspeakers: the left rear loudspeaker at REAR L; the right rear loudspeaker at REAR R. Push the connector clip down and insert the end of the wire into the opening: the positive wire (the one with the black line) to the red loudspeaker connection; the negative wire to the black loudspeaker connection. Do not insert the wires too far. The Surround Sound loudspeakers should always be located behind or to either side of the listener. If preferred you can also hang the loudspeakers on the wall.
&
Connect two rear loudspeakers with built in amplifiers (or an audio amplifier with rear loudspeakers). Connect the audio cables to the rear loudspeakers and to the Dolby surround output S at the back of your TV as shown above. There is only one cinch output for both speakers. Use a mono to stereo adaptor. Note: Switch off the TV and the rear loudspeakers before connecting them. Select Rear speakers Yes in the Setup menu. See p. 7. See Surround settings, p. 14 for the available Surround modes. Rear Surround Sound loudspeakers should always be located behind or to either side of the listener at about 1 m above the seated listener�s head. Adjust the volume of the rear loudspeakers. You can use - the Test tone function in the Surround settings menu, see p. 13, as a reference to set the volume level of the separate loudspeakers. Note: Once you have adjusted the volume of the rear loudspeakers, do not change it while watching TV, the volume level of all the speakers is changed with the volume control of the TV.
é
é
Select Rear speakers Yes in the Setup menu. See p. 7. See Surround settings, p. 14 for the available Surround modes. Rear Surround Sound loudspeakers should always be located behind or to either side of the listener at about 1 m above the seated listener�s head. Adjust the volume of the rear loudspeakers. You can use the Test tone function in the Surround settings menu, see p. 13, as a reference to set the volume level of the separate loudspeakers. Note: Once you have adjusted the volume of the rear loudspeakers, do not change it while watching TV, the volume level of all the speakers is changed with the volume control of the TV.
�
�
Connect Peripheral Equipment
27
|
|
|
> |
|
