|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
The ease of this purchase was a good start. The content of this manual was exactly all I needed to retore my Tandberg 64.
All of the mechanical and electrical information is contained in the manual and the quality of the document makes reading the data easy.
The exerience with the resource has made this my prime source for technical data.
;
Owner-manuals.com is the best Possibility to give vantage HIGH CLASS Elektronic COMPONENTS
a new Life.Thanks alot for your perfekt Service.
;
I am proud of you. In the future, I benefited from your services.
;
I found this manual to be complete in every detail. Besides the schematic it has a complete set of alignment instructions which are easy to understand. It also includes a complete parts list as well as an explanation of how the power supply and safety shutdown circuits operate. Even a schematic of the tuner is included.
 ;
The product was good and just what I needed, however I had moderate difficulty with the down load because the sight would not recognize my pass word. I was finally given a direct link to the manual and that worked.
34N-WF5H
DRESSING THE LEADS
Insert NS. Insert EW �2 Insert GS and dress the leads with no slack. Fold back and bundle the leads. Insert EW Speaker boxe:RSP-Z0109CEZZ x2 Place the speaker boxes in position and tighten the 4 screws. Screw:LX-TZ3096CEFD �4 Tightening torque: 1.17 ±0.19 N-m (12 ±2 kg-cm)
Screw
Screw
Bundle K, GS, EW and NS. Insert GS. Bundle K. Connect K. Connect M. GS SH Bundle M and EW.
Insert the PWB (until securely locked). å Anode clamp: LHLDW1087CEKZ x2 Reposition the anode clamp. Keep the CRT and other leads Connect the anode 10 mm or more away (after connecting the from the anode lead. coating ground lead). Couple the speaker connectors (for both sides).
Remove the pin cover and fit the CRT PWB.
Couple the speaker connectors (for both sides).
The wider side is the positive terminal. Do not confuse the right and left speakers. Their polarities are different from each other.
Connect the coating ground lead (2 points). Dress the speaker leads (for both sides). Catch them at the hooks indicated. GS å Bundle the K and anode leads. SH
Dress the speaker leads (for both sides). Catch them at the hooks indicated. Connect Pu. Insert SH. Connect M. (Keep the M leads tight.) Pu/Mg
Earth å Secure the CA leads at 2 spots. å Secure the AC cord at 2 spots. Place the core between the two wire holders. å Insert the AC cord holder (LHLDK0014PEZZ) into the indicated recess.
10
|
|
|
> |
|
