|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Very comprehensive document which is a must-have for any Satellit 2100 owner whose set up is somewhat intricate. Due to the bad quality of the pictures that are rather dark and a bit blurred I gave 4-star feedback.
;
The manual was missing 2 pages but when I presented the problem to the company they made every attempt to get the 2 pages to me, when they couldn't they refunded my money. A very pleasing and easy transaction. The manual they provided was the original, it was concise and to the point. I plan to do business with this company again when should the need arise.
 ;
The owners manual is very good. all my how to questions were answered in detail.
;
Irrespectively of this manual exist only germany language, it's useful - although i need some additional task to translate: My english is bad, but usable - but i really dont speak germany. :)
;
Excellent service from this company (including a total refund on an earlier purchase when through no fault of the company the manual was incomplete). I have purchased several manuals which I have been very satisfied with, as I am with this one. Highly recommended.
B
A
Surround loudspeakers There are two surround loudspeakers supplied. One is the active loudspeaker A.The other loudspeaker B is a passive one which has to be connected with the active loudspeaker.
�
4 1 2 3
Connect the active to the passive loudspeaker with the supplied speaker cable 1. Insert the marked wire into the openings of the same coloured connector clips on both speakers. Do not insert the wires too far. The Surround sound loudspeakers can be located behind or to either side of the listener.The front of the loudspeakers do not have to face the listener. Set the position switch 2 to the right if the active loudspeaker is positioned to the right side of the listener, to the left if it is positioned to the left side of the listener (seen from the point of view of watching the TV). Connect the 3,5 mm jack cable with the connector at the back of the active surround loudspeaker and with the black and red REAR R or L outputs at the back of the TV. Connect the active loudspeaker to the mains with the mains cable 3. Switch on the active loudspeaker with the POWER switch 4. The red indicator at the front of the active surround speaker shows that the speaker is in standby. During sound transmission the indicator turns to green. 10-15 min. after the sound transmission of the TV has stopped, the indicator turns back to red to indicate the low power standby. To switch the active speaker off, use the POWER switch.
� �
�
� �
REAR
4
Preparation
|
|
|
> |
|
