Thanks to Owner-Manuals.com! This manual was exactly what I needed. As Amana was purchased by Maytag and later by Whirlpool, there was no way to receive it from their websites. I was lucky to find this resource.
A comprehensive Operating and Service Manual. All schematics are complete and easy to read. The PCB drawings and complete parts list are very helpful. I would definitely recommend this manual.
Select the menu language
1 Press the MENU button on the remote control. 2 Use the cursor down to select Install in the Settings menu.
3 Use the cursor right to enter the Install menu. 4 Select Language and enter the list of available languages with the
cursor right. 5 Select your preferred language with the cursor up/down and press the OK button to con�rm your selection. 6 Proceed with the Install menu.
Press the MENU button on the remote control. Use the cursor down to select Install in the Settings menu. Use the cursor right to enter the Install menu. Press cursor down to select Auto store in the Install menu. to start scanning of channels.
5 Use the cursor right to enter the Auto store menu and press OK
Auto storing may take up to 3 minutes to complete. Please wait until Auto storing is completed . The TV will then switch automatically to the �rst channel found.
Notes: � Immediately after unpacking and plugging in your new television, run the auto store function to set up the TV for the broadcast or cable channels available in your area. If you do not run the auto store function to set up the channels, your television may not operate properly. � After you�ve run Auto store, check out the results. Press P (+) or the P (-) button and see which channels you can select. � Remember, an antenna or cable TV signal must �rst be connected to your LCD TV.