Being a user of older radios of many kinds, preferring them over more modern rigs, this manual was invaluable in the programming of my two. I now know for certain what the assorted buttons functions are, and am very grateful to have found this excellent site. Many thanks for your assistance, Tony.
5 star quality on these downloadable manuals. Easy to read and all the information is there. A must when doing a custom install or needing to service your precious old school electronics.
Select the menu language
1 Press the MENU button on the remote control. 2 Use the cursor down to select Install in the Settings menu.
3 Use the cursor right to enter the Install menu. 4 Select Language and enter the list of available languages with the
cursor right. 5 Select your preferred language with the cursor up/down and press the OK button to con�rm your selection. 6 Proceed with the Install menu.
Press the MENU button on the remote control. Use the cursor down to select Install in the Settings menu. Use the cursor right to enter the Install menu. Press cursor down to select Auto store in the Install menu. to start scanning of channels.
5 Use the cursor right to enter the Auto store menu and press OK
Auto storing may take up to 3 minutes to complete. Please wait until Auto storing is completed . The TV will then switch automatically to the �rst channel found.
Notes: � Immediately after unpacking and plugging in your new television, run the auto store function to set up the TV for the broadcast or cable channels available in your area. If you do not run the auto store function to set up the channels, your television may not operate properly. � After you�ve run Auto store, check out the results. Press P (+) or the P (-) button and see which channels you can select. � Remember, an antenna or cable TV signal must �rst be connected to your LCD TV.