|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
- Very good scan quality, PERFECT!
- Sehr gute scan Qualitaet, empfehlenswert!
Wolfgang Sundhaus
 ;
Good site, works ok and you get what you order, no problems experienced, got my manual within a day. A++++
;
Original well scanned manual. Got the job done. Microwave problem found & corrected. For $5 and a new magnitron from ebay, it was a cheap and good the first shot fix. Electrical schematics allowed me to mage sure every thing else was ok before cutting and order for parts. Hard to live without.
;
I was very skeptical of this website, I have never downloaded manuals before. I put it on the AMEX and payed through Paypal to ensure protection. I got the manual exactly as described and now I can replace the filter capacitor for this amp. Great Price, others selling for 12.99 or more and this is the same manual. I will search out this website for other manuals. Thank you
;
Manual was reasonably easy to follow. I am not an engineer or know much about electronics but with the manuals help I was able to figure out the problem, identify the part required for the repair. Replacement part cost around $30. Whilst replacing the part I was telling myself, "this aint gonna work cos it seems far too easy". Took about 15 minutes to do and my plasma TV works a treat. Would never have been able to do this without the service manual.
8.2.
PAL/SECAM panel white balance
INPUT Equipment Color Analyzer Setting Picture: Normal Sub Adjust White balance: Sub Bright Cool Aspect: PANEL W/B 16:9 G cut off PANEL W/B B cut off R cut off Sub Adjust Sub Bright Alignment menu Procedure 1) Find the nearest area to brightness of 10 cd/m2 as Low light by color sensor. 2) Adjust Sub bright to set Low light level to 10 cd/m2 exactly. 3) Set G cut off to " 80 ". 4) Adjust B and R cut off to set color temperature as shown Fig.-02. 5) If Sub Bright is changed re-adjust it to set Low light to 10 cd/m2. 6)Find 75% of white area by color sensor. PANEL W/B G Drive 7) Set G Drive to " D8 ". PANEL W/B B Drive 8) Adjust B and R Drive to set color temperature R Drive as shown Fig.-02. 9) Repeat procedure 4) to 7) to set both Low light and high light. PANEL W/B R,G,B Drive 10) Increase same steps of R, G and B Drive to set R,G,B Drive largest level of 3 color drive to "FC". PANEL W/B R,G,B cut off 11) Re-adjust Low light level again. Color Temp. Cool(Hi) Normal(Mid) Warm(Low) x 0.272 0.288 0.313 Fig. -02 y 0.290 0.296 0.329
1 PAL Gray Scale Pattern
High light 75% Low light 15%
2
Picture:
1) Change white balance to "Normal".
Normal PANEL W/B White balance: R,G,B cut off 2) Repeat procedure 3) to 11) of Cool mode. Normal PANEL W/B Aspect: R,G,B Drive 16:9
3
Picture:
1) Change white balance to "Warm".
Normal PANEL W/B White balance: R,G,B cut off 2) Repeat procedure 3) to 11) of Cool mode. Warm PANEL W/B Aspect: R,G,B Drive 16:9
4
Picture Menu 1) Change color templature to "Cool". Normal Sub Adjust White balance: Sub Bright 2)Re-set Sub bright to "30" Cool Aspect: 16:9
Picture:
16
|
|
|
> |
|
