|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
- Very good scan quality, PERFECT!
- Sehr gute scan Qualitaet, empfehlenswert!
Wolfgang Sundhaus
 ;
Good site, works ok and you get what you order, no problems experienced, got my manual within a day. A++++
;
Original well scanned manual. Got the job done. Microwave problem found & corrected. For $5 and a new magnitron from ebay, it was a cheap and good the first shot fix. Electrical schematics allowed me to mage sure every thing else was ok before cutting and order for parts. Hard to live without.
;
I was very skeptical of this website, I have never downloaded manuals before. I put it on the AMEX and payed through Paypal to ensure protection. I got the manual exactly as described and now I can replace the filter capacitor for this amp. Great Price, others selling for 12.99 or more and this is the same manual. I will search out this website for other manuals. Thank you
;
Manual was reasonably easy to follow. I am not an engineer or know much about electronics but with the manuals help I was able to figure out the problem, identify the part required for the repair. Replacement part cost around $30. Whilst replacing the part I was telling myself, "this aint gonna work cos it seems far too easy". Took about 15 minutes to do and my plasma TV works a treat. Would never have been able to do this without the service manual.
NOTES: 1. Since the G light is very important for picture quality and performance, pay special attention in its adjustment. 2. Be careful not to touch the lens with your fingers when adjusting. (5) In case of R lens. Set the position where the chromatic aberration changes from red to crimson. As shown below, observe the vertical bright line and adjust lens focus where the crimson or red chromatic aberration slightly appears inside and crimson or red outside (reference value : 1~3mm) at the point specified in table below. Change the signal and fineadjust in the same way as the G lens. L
OPTICAL FOCUSING ADJUSTMENT BLUE
CHASSIS SCREEN SIZE L1 and L2 (PITCHES from CENTER) L1&L2 COLOR ABERRATION I 43GX10B/50GX10B 43� 50� 3.0 3.0 50DX10B/60DX10B 60� 50� 3.0 3.0
* * ** ** * * ** ** 2mm MAX 3mm MAX 3mm MAX 2mm MAX ** ** * *
(NOTE)
O 2mm MAX 3mm MAX 2mm MAX 2mm MAX * Slightly reddish or no color ** Slightly reddish or no color
Adjustment Procedure (7) After all colors have been adjusted, display all colors with the cross-hatch pattern signal and compare the focus (optical focus) performance with the limit sample set. (8) Then, select the circle pattern signal and compare the focus (optical focus) performance of each color and all colors together with the limit sample set. (9) If the focus performance is worse than the limit sample set, re-adjust step (1) to (6).
I
CHASSIS SCREEN SIZE L1 and L2 (PITCHES from CENTER) L1&L2 43GX10B/50GX10B 43� 50� 3.0 3.0
O
50DX10B/60DX10B 60� 50� 3.0 3.0
2.5 STATIC FOCUS ADJUSTMENT
Adjustment preparation (1) LENS FOCUS adjustment should be finished. (2) Contrast : MAX Brightness : Center. (3) Receive the circle pattern signal. (4) Apply covers to the lens of the colors you are not adjusting and project only one color on the screen. Adjustment procedure (1) Red and blue static focus adjustment. Adjust the static focus VR on Focus pack (UFPK) so that the center of circle pattern is the most clear. Check that the focus does not get conspicuously worse at the edges of the circle pattern signal or cross-hatch signal. (2) Green static focus adjustment. Adjust the static focus VR on Focus pack (UFPK) (for green) so that the center of circle pattern is the most clear. Check that the focus does not get conspicuously worse at the checking point, the periphery of circle pattern cross-hatch signal. NOTE: Checking point for the periphery of picture.
OPTICAL FOCUSING ADJUSTMENT RED
COLOR ABERRATION
(NOTE)
* * ** ** * * ** ** I 2mm MAX 3mm MAX 3mm MAX 3mm MAX ** ** * * O 2mm MAX 3mm MAX 3mm MAX 3mm MAX * Slightly reddish or no color ** Slightly reddish or no color
NOTE:
Setting the center between Red and crimson is optimum.
(6) In case of B lens. Set the position where the chromatic aberration changes from purple to green. As shown below, observe the vertical bright line and adjust lens focus where the purple or green chromatic aberration slightly appears inside and purple or green outside (reference value : 1~3mm) at the point specified in table below. Change the signal and fineadjust in the same way as the G lens. L
NOTE:
I O Setting to the center between purple and crimson is optimum. Checking point
28
|
|
|
> |
|
