|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Item as described, very well detailed manual with complete schematics. I've received the download information shortly after payment, very good support.
 ;
Really good and well scanned. File is complete the full service manual for 5$
;
Good product and very helpfull to repair. Many thanks.
;
Very good product. Best service manual. Many thanks
;
I am only search for 5 Minute, by it in 5 Minutes to and get ist in few ours! Best i found in the Internet and my Amplifer is repaired as well! Thank you
9. CWI/NDC Adjustment
(Base value --> CWI: 160, NDC: 12)
9-4. NDC Adjustment
NDC Mode is for compensating the deviation of each Lamp. Adjust Left/Right value with using CH UP/DOWN key on the Remote Controller to set an uniformity for White color.
9-1. Required Test Equipment
Remote Controller
9-2. Preparation for Adjustment
(1) Connect power and turn the TV set on. (2) Enter to CWI/NDC.
Starting point of noise (Appearance GREEN)
<Fig. 10> TEST Pattern The sensitivity of sensor may vary due to the temperature. Thus it may cause color changed bacause of the color wheel angle changed. <Fig. 8> TEST Pattern(Lamp Gray Pattern)
9-3. Adjustment
(1) Using the channel key, adjust CWI-Pat.1 to the left/right. (2) During adjustment, check the appearance of noise in the TEST Pattern. Set the value to reduce green noise in step 3~4. (3) Using CH UP/DOWN key of the Remote Controller, enter the RED PATTERN. (4) Check the uniformity of RED Pattern to verify.
<Fig. 9> TEST Pattern(RED Pattern)
- 15 -
|
|
|
> |
|
