|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
This scanned manual is well done in that most all the pages except for one is straight and clear- the way I would do them. One page was upside down but that happens. For the money that is charged on this site you get a pretty good deal. Now with complex repairs, I still prefer to us paper manuals which I have to buy at stereomanuals but the one I got here was much less than the $45 he was charging but this is a larger than normal manual for three different units. I am a picky manual user because I have used original manuals from Sony and Teac.
;
Very useful service manual, was exactly what i needed.Good quality,reasonable price.Thank you.
;
Acurate informations inside the SM and I could repair my old Sansui SC-3330 without any problems. Thanks.
;
I used it to repair a NAD 7030, but unfortunately, the 7045 is different !
But documentation was useful.
;
Content A4 and A3 format pages. Exactly what I needed to restore my old receiver.
4080-001
Exit Roller Assembly Removal
1. Remove the input / output tray assembly. 2. Remove all covers, refer to �Covers and Doors� on page 4-3. 3. Remove the carrier frame assembly, refer to the �Carrier Frame Assembly Removal� on page 4-11. 4. Remove the three screws from the right side frame and remove the frame. 5. Remove the exit roller.
Gear Box Assembly Removal
1. Remove the input / output tray assembly. 2. Remove all covers, refer to �Covers and Doors� on page 4-3. 3. Remove the carrier frame, refer to the �Carrier Frame Assembly Removal� on page 4-11. 4. Depress the plastic clip on the clutch lever at the end of the large feed roller shaft and remove the clutch lever. Be sure the grove on the clutch lever aligns with the clutch spring. 5. Remove the two screws securing the gear box assembly to the frame. 6. Depress the gear box clip on the bottom of the left side frame and remove the gear box assembly and shaft.
Large Feed Roller Removal
1. Remove the input / output tray assembly. 2. Remove all covers, refer to �Covers and Doors� on page 4-3. 3. Remove the exit roller assembly, refer to the �Exit Roller Assembly Removal� on page 4-15. 4. Unlatch the spring at the left end of the large feed roller shaft, by lifting up on the latch release lever. 5. Remove the tension spring from the end of the large feed roller shaft and remove the large feed roller.
Repair Information 4-15
|
|
|
> |
|
