|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
The manual was a perfect match and was exactly what I was looking for. I'm very satisfied with my purchase.
;
Thank you for having the manual I needed for an older model Aiwa stero I had found on Ebay --- I wanted the Aiwa because I had tapes and cd's but I did not have a manual as to how to operate the system... I found what I needed and it has enabled me to set the system up for my enjoyment.
;
I wished detailed information of the JBL S310 and here I found it! Very happy with the service from this site!
;
The manual was very helpfull, it answerdes all my questions, and i was surprized to find the original manual on this site! Big thumbs uP:)
 ;
helpful manual.good service.Quick response.will use again
Section 3
Configuring the DriveRack�
3.5- H Driver Alignment Delay
DriveRack
�
The second Delay section of the DriveRack� units is used to fine tune delay times within an enclosed speaker or an array of speakers. Enter the Configuration creation section of the DriveRack� by pressing and holding the PROGRAM/CONFIG button. Now use the PARAMETER 2 and 3 knobs to move to the selected output Delay section.
3.5- I Output Routing and Phase Compensation
From the Configuration creation mode, the DriveRack� gives you the option of routing any digital output to any of the eight analog outputs of the DriveRack� unit. This means that the digital output signal can be routed to any one of the eight physical outputs. Options for numbering Outputs names include: 1-8 . This means that two signals that are sent to the same output, will be summed to one output that shares the same name. In addition to output routing, each output section of the DriveRack� unit offers phase compensation within the selected output module.
3.6 Linking Modules
The DriveRack� provides the user with an option to link like modules together (ie; four 31 band Graphic EQs and so on) so that when a change is made in a selected program to one module, the change will affect all of the like modules. This linking feature can be applied to every module used in any single configuration. The following procedure will illustrate how to perform this feature.
� While you are in Configuration mode, use the PARAMETER 2 and 3 to scroll to the module section that you wish to link. For this example, we will use the Graphic (G) EQ modules. Once a single Graphic EQ module has been selected, you can select all of the Graphic EQ modules by pressing the PARAMETER 3 knob, and the display will appear something like this:
� At this point, rotate the PARAMETER 3 knob to select all four Graphic EQ modules, then press the PARAMETER 2 knob to link the modules together. Once this has been done,
®
28
DriveRack� User Manual
|
|
|
> |
|
