|
|
|
Who's Online
There currently are 5943 guests and
2 members online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
The manual I purchased was just what I needed. I was glad to find a site where I can find so many manuals on a wide variety of products.
;
The best diagram that I used in a long time. Everything was right on te money. It was easy and fast. Iwoiuld but again when I need a service manual.
;
The manual is great help for me, i'm happy to have it,thanks
 ;
Very pleased with manual except that a few more details in the drawings might make the job (not yet done, tut-tut) easier. Should be adequate though. Actually I didn't have to pay for this anyway as I was given credit for another item that wasn't quite complete. Good service, then.
;
Very useful manuals, somewhere graphics not very clear!
Adjustment items Focus adjustment The method mentioned left is applied to the focus adjustment on the G lens adjustment of 43PH, 42W.The details of G lens adjustment for 50PH,61PH, 50W, and 57W are described in the previous page.
Adjusting methods 4) Adjust the G lens focus. (Applicable only to 43PH, 42W) Watch the horizon of the left and right both ends of the screen (the range of circle with 100mm diameter shown in the following sketch), make optimum adjustments on the G lens focus, and check that the focus balance on the right and left is satisfactory. (Balance check of left-and-right G lens focus) (1) Adjust the G lens focus best by crosshatch of the left end (or the right end). (2) Check the focus of the right end (or the left end). If the balance of the left and right lens focus (flare) is different, part it and adjust to the medium quality. Check the environment and confirm that the focus quality (including flare) is within a tolerable range.
Point to be noted during G lens focus adjustment (To be adjusted within circles of 100mm diameter contacting the left and right of the bezel)
Concerning items 1), 2), 3), and 5) of G adjustment, these are common to the ones on the previous page. 3. R adjustment 1) Set to the R monochrome by lens cap. 2) Receive the image of Retma pattern. 3) Adjust the R electrical focus. Adjust by focus volume of the focus block (Z410) so that the screen center will come to optimum focus. 4) Adjust the R lens focus. Adjust so that the screen center will become the best. 5) Repeat 3, 4, and attempt to further improve the focus quality.
� 17 �
SPECIFIC INFORMATIONS GENERAL ADJUSTMENTS
|
|
|
> |
|
