|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Great Manual. This manual is available no where else. It was exactly what I was looking for.
;
The TEAC A-1500's Service Manual was instrumental in reviving this classic reel-to-reel. Not only does it have the schematics, exploded parts diagram and parts list, it also provided mechanical adjustment information that approximate factory default settings.
 ;
This service manual was determinant to enable to fix my Alpine Amplifier. I am pleased with my purchase. For a 5 star rating I would like to see a higher resolution scan of the printed circuit board lay-out because the gray scale grafics was dificult to see. Also some schematic diagrams were scanned at a slight angle. Never the less, it had all information I needed to troubleshoot and service my equipment.
;
Complete manual, the good quality of reproduction allows enlarged print-out of the schematic diagram in the size it probably had in the original print edition and which is necessary for practical use.
;
The service manual was complete and the components on the drawings very good visible.
Manually adding and deleting channels in the channel memory
After you have programmed the channels automatically, you can manually add or delete individual channels in the channel memory. To add or delete channels in the channel memory: To add a channel to the channel memory: Highlight the unchecked box next to the channel number you want to add, and then press ENTER to check the box. To remove a channel from the channel memory: Highlight the checked box next to the channel number you want to remove, and then press ENTER to uncheck the box. To save your new settings: Highlight SAVE and press ENTER. To revert to your original settings: Highlight CANCEL and press ENTER before saving. To remove all channels from the channel memory: Highlight CLEAR ALL and press ENTER, and then highlight SAVE and press ENTER. Note: This action cannot be cancelled unless you highlight CANCEL and press ENTER before saving your changes.
1 2 3
SPECIFIC INFORMATIONS GENERAL ADJUSTMENTS
Press MENU and open the SETUP menu. Highlight INSTALLATION and press ENTER. (A new set of INSTALLATION menu icons will appear on screen, as shown in step 3). Open the TERRESTRIAL menu, highlight CHANNEL ADD/ DELETE, and then press ENTER. The illustration below shows channels programmed for the ANT 1 antenna input. To view the list of channels programmed for the ANT 2 antenna input, highlight CHANGE ANTENNA and press ENTER.
4
� 22 �
|
|
|
> |
|
