|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Quick response and exactly what I was looking for and at a great fair price!
;
5 star quality on these downloadable manuals. Easy to read and all the information is there. A must when doing a custom install or needing to service your precious old school electronics.
;
So usefull to make my installation a breeze. 5 stars on quality.
;
very helpful, the information in these manuels are very detailed
;
Please tell us what you think and share your opinions with others. Be sure to focus your comments on the product. You will receive $2.00 of store credit for Your review.
52C SERIES
I
INSTALL CHASSIS IN SLEEVE (See Figures 5 and 6) 1. Inspect foam gaskets (top, bottom, both sides) on chassis. Replace foam gaskets if torn or missing. IMPORTANT: The gaskets combine with the sleeve face to create a weather barrier. If the chassis is installed in a non-Carrier sleeve, this weather barrier may not be effective.
SIDE GASKET
TOP GASKET
Chassis weighs up to 150 lbs. For personal protection, seek help when lifting the unit. Lift unit by holding unit basepan. 2. Lift chassis level with wall sleeve. 3. Slide chassis into wall sleeve until foam gaskets rest firmly against front of wall sleeve. 4. Screw chassis to wall sleeve with four 13/4-in. long screws taped to the control box. Screw holes are located on both sides of the mounting angles of the chassis. Use only the top and bottom screw holes on each side. See Figure 7.
BOTTOM GASKET
COIL TUBE SHEETS
FIGURE 6 � 52C UNIT GASKETS AND TUBE SHEETS
TOP SCREW HOLE
BOTTOM SCREW HOLE
FIGURE 7 � CHASSIS MOUNTING
6
|
|
|
> |
|
