|
There are currently no product reviews.
 ;
As Always you can find here manuals even of difficult TV scheme which are scan in almost perfect way.clear and fast!!!!!
Great work thanks!
;
Incredibly clear!!!! Well done, complete and wonderful. It could not better than this!!!!
 ;
Thank You for fast delivery for the sheme.
Everything allright.
Thanks & best regards Franz
;
again you did a very good job. It was fast too. Photocopy are really readable and clear
;
Probably it never existed a 1081 official service manual from Commodore, it's look more like a NAPCEC service manual & diagrams compilation of the 1084 series and his variants, like the nap6523, 8cm505, 1084S, 1084P and obviously the 1081. It's more complete than other scans and the quality of the scans also are far superior. It has two circuit diagrams variants of the 1081, mono and stereo versions. It doesn't include a diagram for the Philips CM8500 or CM8501, they look like the 1081 but they are slightly different.
1. Loosen the lock nut on each Adjustment Post. This will require a 4mm wrench. 2. Using a #15 Torx, loosen the Centering Bracket. 3. Place a 1/4 inch or 6mm rod in the Center Reference to keep the Light Engine Centered. 4. Adjust the Tilt Adjustment screws to make the Light Engine parallel with the cabinet. 5. Turn the set on and apply a crosshatch pattern to the set. 6. If the picture is tilted, use adjustment post 2 to correct the picture. Use an E4 inverted hex to adjust the post. 7. If the picture is high or low, use adjustment post 1 to correct the picture. 8. If the picture is shifted to the left or right, use adjustment post 3 to correct. 9. If the picture is still shifted to the left or right, remove the Centering Rod and slide the assembly to correct the picture. 10. Tighten the Centering Bracket. 11. Tighten the Lock Nut on each of the adjustment post. To prevent the post from turning, place the inverted hex over each post. 12. Remove the Centering rod. To purchase the E4 Hex socket, go to www.stanleyproto.com. Order item 6904TX.
|
