|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
The purchased manual is an high quality scan of the original Philips paper-based Service Manual. I am very satisfied!
 ;
The purchased manual is an scan of the original Panasonic paper-based Service Manual. Unfortunately the contrast is not perfect, but I am satisfied anyway!
;
The purchased manual is an high-quality scan of the original JVC paper-based Service Manual. The Service Manual includes the Owner´s Manual, so you do not have to buy both of them.
;
It paid to find this Service Manual, couldn't find it anywhere else. Exactly what I wanted. Received within 24 hours.
;
Complete manual with clear schematic diagrams and printed circuit board layouts of two variants of the headset and the transmitter an old and a new version.
Also shows how the headset and the transmitter is opened and how transmitter and receivers can be adjusted and where to measure.
I had no problems to repair the headset using this service manual.
Manually adding and deleting channels in the channel memory
After you have programmed the channels automatically, you can manually add or delete individual channels in the channel memory. To add or delete channels in the channel memory: To add a channel to the channel memory: Highlight the unchecked box next to the channel number you want to add, and then press ENTER to check the box. To remove a channel from the channel memory: Highlight the checked box next to the channel number you want to remove, and then press ENTER to uncheck the box. To save your new settings: Highlight SAVE and press ENTER. To revert to your original settings: Highlight CANCEL and press ENTER before saving. To remove all channels from the channel memory: Highlight CLEAR ALL and press ENTER, and then highlight SAVE and press ENTER. Note: This action cannot be cancelled unless you highlight CANCEL and press ENTER before saving your changes.
1 2 3
SPECIFIC INFORMATIONS GENERAL ADJUSTMENTS
Press MENU and open the SETUP menu. Highlight INSTALLATION and press ENTER. (A new set of INSTALLATION menu icons will appear on screen, as shown in step 3). Open the TERRESTRIAL menu, highlight CHANNEL ADD/ DELETE, and then press ENTER. The illustration below shows channels programmed for the ANT 1 antenna input. To view the list of channels programmed for the ANT 2 antenna input, highlight CHANGE ANTENNA and press ENTER.
4
� 22 �
|
|
|
> |
|
