|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
This PDF is very comprehensive. It includes drawings, parts lists, schematics, pictures, PCB drawings, mechanical layouts, etc. for all three stackable equipment. The scans are good too. Easy to read and no smudges or black lines. I have no complaints. I will make this site my first stop for finding my service manuals.
 ;
This service manual includes drawings, schematics, exploded views, parts list, operating details, and more. Very good scans, very readable. The only thing that made it a 4 star rating was on approximately 4 scans only half of the page was scanned then the other half. I would have preferred the pages to be whole scans.
;
Good manual contains all it takes to update, repair,these types of mixers.Thanks.
;
Great service. Fast response. High quality scan. Good price.
Thank you very much!!!
Oleg S.
;
Well-scanned, complete manual. Contains the information needed for repair and maintenance.
Reference Notes in the Table
Caution ! When removing the CRT, be sure to discharge the Anode Lead of the CRT with the CRT Ground Wire before removing the Anode Cap. Reference Notes in the Table CAUTION 1: Discharge the Anode Lead of the CRT with the CRT Ground Wire before removing the Anode Cap. 1. Disconnect the following: Anode Cap, CN501A, CRT CBA, CN571, CN601, CN802, and CN1801. Then remove Tray Chassis Unit. CAUTION 2: Electrostatic breakdown of the laser diode in the optical system block may occur as a potential difference caused by electrostatic charge accumulated on cloth, human body etc., during unpacking or repair work. To avoid damage of pickup follow next procedures.
2-1. Remove screws (S-6), (S-7) and 2(S-8), and remove Loader Shield Top. 2-2. Disconnect Connector (CN301) on the DVD Main CBA Unit. 2-3. Short the three short lands of FPC cable with solder before removing the FFC cable (CN201) from it. If you disconnect the FFC cable (CN201), the laser diode of pickup will be destroyed. (Fig. 4) 2-4. Remove two screws (S-9) and remove DVD Main CBA Unit. CAUTION 3: When reassembling, confirm the FFC cable (CN201) is connected completely. Then remove the solder from the three short lands of FPC cable. (Fig. 4) 4. Remove three screws (S-13) and remove Top Shield. Remove screws 7(S-14), (S-15) and (S-16). Then, desolder connectors (CL201, CL401, CL402, CL403) and lift up the Deck Assembly.
(S-1) (S-1) (S-2) (S-1) (S-3)
(S-3) (S-1) (S-1)
(S-1)
[1] Rear Cabinet
Fig. 1
1-6-2
T2001DC
|
|
|
> |
|
