|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
This was super service.Ordered this manual and was reading the download an hour later
;
as always, rapid and efficient, very good and clear prints
details clearly visible keep going this way!!!!!!
;
I expect a wonderful result as alaways!!!!!!
Usually is much faster....
;
Wow very wonderful and clear!!!! I will always trust them
;
Providing the manual works fine, quickly and without any problems for an acceptable price. After printing the service manual it took me only a short time to repair my carradio from Clarion. Thank You! Greetings from Heiko
Exchange of LBE, LBF board
1 2 3
(Photo 1)
(Photo 2) 1. Remove the screws in order of 1-3-2 from heat sink and then get rid of heat sink. (Photo 1) 2. Remove the TPC, FFC and power cable from the connectors. 3. Remove all of the screws from defected board. 4. Remove the defected board. 5. Replace the new board and then screw tightly. 6. Get rid of the foreign material from the connector. 7. Connect the TCP, FFC and power cable to the connector. 8. Reassemble the TCP heat sink. 9. Screw in order of 2-1-3. (Photo 2) If you screw too tightly, it is possible to get damage on the Driver IC of TCP.
Exchange YB and YM board
1. Separate all of the FPC connector of YB. (Photo 1) 2. Loosen all of the screws of YB and YM. 3. Remove the board from chassis. 4. Remove the connector of CN5004, CN5011, CN5012 among YB and YM. 5. Remove the YB from Y-main.
2-4-5
PZ3PDMDA
|
|
|
> |
|
