|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
manual de usuario perfecto y completo de buena calidad de impresion y muy detallado ideal !
 ;
It`s full copy of a service manual from url http://www.philips.owner-manuals.com/PM3216-service-manual-PHILIPS.html
;
perfect! you just sent to me the copy in Italian witout even my specification!!!! so you are really smart cooperative and efficient. To my opinion the best place all over to get a manual of electronics!!!!
;
Well Well Well!!!! Good manual perfect for my hobby!!! As Before you have done a very well done work!!!! Thank you
;
Super nice! Good to have a manual in digital format.
20
ENGLISH
ENGLISH
6
21
C
The amount of cleaning solution in the transparent cleaning reservoir is visible on both sides of the Jet Clean System. When the level gets low, refill with Philips Norelco HQ200 Cleaning Solution.
C
� The cleaning solution is automatically supplied from the reservoir to the cleaning canister through a special mechanism in the reservoir cap.
Connect the small plug to the Jet Clean System. Connect the charging plug into any 100V to 240V AC outlet. Use only the charging plug provided. The razor holder automatically moves up to the highest position. 2. Place the Jet Clean System on a flat, level surface. Fill the cleaning reservoir with cleaning solution (see �Preparing Jet Clean System For Use�). Remove protective razor head cap from razor.
1
C
7
Replace cap on reservoir (2) and turn clockwise (1) making sure cap is screwed on securely.
C C
3
� The cleaning solution may foam if the reservoir level is too low.Discard remaining solution,rinse the reservoir with warm water from the tap and refill with new cleaning solution. � If you clean your razor every day, you should refill the reservoir approximately once a month.
C
8
Carefully lower the cleaning reservoir back into the Jet Clean System making sure the reservoir is properly aligned with the base unit.
Place the razor head side down in the razor holder so that the razor head fits into the configuration shown inside the Jet Clean System. Gently press the base of the razor towards the back of the Jet Clean System so that the razor base fits snugly in place. Lock the razor into place by pushing the lever down completely. The charging light will blink to indicate the razor automatically begins to charge. Press the ON/OFF button to start the cleaning cycle. The cleaning light on the Jet Clean System starts blinking and the razor is automatically lowered into the cleaning solution.The razor stops charging while it is cleaning. 5
4
C
Jet Cleaning the Razor
� If the razor does not contain enough power for one (1) shave, the Jet Clean Cleaning System may not work properly. Charge the razor in the Jet Clean System before using it to clean your razor.
|
|
|
> |
|
