|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
It is perfect, exactly what we needed. It's like the paper version but less clutter.
 ;
Received my manual within 24 hours. Very clear scan of the manual I needed. Thanks!
;
Very clear scan, I recommend it. Definitely a must have for any 3362 owner.
Alpine could have written a slightly more complete manual, though. It's already pretty huge, but the unit has so many functions, I feel some more explanation would have been better.
Yamaha's manual of their comparable YDSP-1 is a little better in my opinion.
;
Immediate response with excellent service - highly reccommended
;
Correct manual received and of good quality but the contents of the file for the Service Manual for the same monitor is for a 20" TV not the RGB Monitor.
24
ENGLISH
5 6 You can store the razor in the charging stand. Put Protective Razor Head Cap on razor to protect heads.
ENGLISH
25
Do not clean more than one cutter and comb at a time, since they are all matching sets. If you accidentally interchange the cutters and combs, it could take several weeks before optimal shaving performance is restored. 5 Separate the cutter from the comb and clean with a small brush or rinse clean under hot water. Replace the cutter back onto the Razor Head Assembly making sure the blades are pointing upwards.
Note: If lotion build-up has occurred, remove Razor Head Assembly and soak for a few minutes under hot water or a degreasing liquid (e.g. alcohol). Be sure to thoroughly rinse Razor Head Assembly under tap water before using razor.
6
Razor Head Assembly: Once A Month
Do not mix up the cutters and combs as the shaving performance may be adversely affected for several weeks before optimal shaving performance is restored. 1
1
Place the razor head comb back onto the Razor Head Assembly. Be sure to replace the comb back into the original razor head before cleaning the next set. 8 Turn the razor head counterclockwise until it locks into place. Repeat the process for the other two sets of cutters and combs.
7
Turn razor OFF. Remove Razor Head Assembly from razor by pulling Razor Head Assembly straight up from razor.
2
9 10
3
Using your thumb and forefinger turn the razor head clockwise and lift the comb off of Razor Head Assembly. Remove and clean one set of cutters and combs at a time.
4
Replace Razor Head Assembly back on razor and push down (you will hear a click). The Razor Head Assembly will only fit correctly in one position on razor. Make sure to align the 2 shaving lotion dispensing holes on the Razor Head Assembly with the 2 shaving lotion tubes on the razor.
|
|
|
> |
|
