The manual was made available promptly. I is a clean scan of the original. I had no problem downloading it. The scan was well centered and cleanly formatted. It is as good a product as can be had without being the original document.
Received downlink in less then 8 hours, Item was in good copy condition, and told me how to program the clock timer. The price was very resonable, and the process was very automated and was GREAT to work with.
I was very pleased with the manual I got for my amateur (ham) radio. Without it I could not figure out how to input and/or change the P/L setting on my radio. It drove me nuts as the radio was essentially useless. That all changed when my manual came. Then it took only minutes and I was done. Now my radio works fine. This is an exceptionally good resource as it's a very easy and user friendly download. Thank you very much! Dziękujemy za!
It answered my question, which was how to load the paper. I did notice that the very end of the manual was not visible.
Text excerpt from page 34 (click to view)
SETTING YOUR REMOTE TO WORK VCRS, CONVERTERS - SEARCH
Y
our TV remote can be set to work your VCR or Cable Converter by what is called the SEARCH method. If the "REMOTE CODE" number method shown in the previous section did not set your remote to work your VCR or Converter, then follow the easy steps listed below. Please read through steps 1-4 before beginning.
CABLE CONVERTER
06
1
06
07 07
08
09
08
1
BEGIN
Press the POWER button on the VCR or Converter to turn the unit ON. Stand at least six feet away from the front of the VCR or Converter. Point the remote toward the unit. HOLD DOWN the SURF and the desired System (VCR or CBL-Converter) buttons at the same time. KEEP HOLDING BUTTONS DOWN.
VCR
09
Six Feet
(minimum)
2
Don't let the VCR or Converter scan up more than five channels (in Search mode).
3
REC q CLEAR PLAY
MENU
STATUS
REW
M
FF
24
3
Watch the Channel Indicator on the unit. Channel Numbers will SCAN UP when the unit has been identified. This may take up to two minutes. Release the SURF and System (VCR or CBL) buttons as soon as channel numbers start to scan up. The code has been identified and the remote is ready to operate with the VCR or Converter.
STOP
MUTE
STOP s
PAUSE II SURF
VOL
CH
ON/OFF
POS
SWAP
FREEZE SIZE
4
100+ TV/VCR SLEEP SMART POWER
ENTER
1 4 7
2 5 8 0
3 6 9
VCR M
CBL O D
TV E
SMART HELP
Remember, a minute or two can seem very long, but the code should be located within two minutes. Don't let the VCR scan up more than five channels. If you do the remote may pass up the right code and another two minute search cycle will have to be repeated. If no channel change happens within two minutes, repeat steps 1-4. Should a channel change still not occur, the remote will not work with the desired unit.
34