|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
This is a great manual. It was easy to read and very accurate. The size of the manual is small so email is no problem. I highly recommend it. The manual is very hard to find other than this website.
;
Manual was complete and available promptly, since I had lost my original manual. Very good response.
;
Whilst this is a photo copy, and some of the pages are a little askew, it was all readable and intact. A real bonus finding an old manual for a classic piece of kit that no other site had.
Great stuff.
;
excellent quality, contains circuits and scan quality, 110 pages
;
It was easy done, and I got exactly what I was looking for.
Connection to other equipment
We have 2 component signal input jacks: Y Cb Cr and Y Pb Pr. The R / L is Audio input for every Y Cb Cr and Y Pb Pr. If your DVD or Set Top Box have Y Cb Cr or Y Pb Pr output, you can connect it to Y Cb Cr or Y Pb Pr input jack. And select to Y Cb Cr or Y Pb Pr source input. �Some DVD or Set Top Box need to set to Y Cb Cr or Y Pb Pr output� Notice: If you see that display abnormality in screen, you need to check the cable connection and DVD setup.
G B R R W
INPUT CONNECTION OF PC SIGNAL(PC/DVD)
Notice: If you see that display abnormality in screen, you need to check the cable connection and DVD setup.
� Notice: The PC output can not set out of range.The highest resolution input is 1280 X 1024 / 60Hz. Some PC models cannot be connected to the set.
24PIN DVI R/L INPUT 15PIN DVI R/L INPUT
� D-SUB 15 Pin: Connect D-SUB signal cable �VGA cable� from PC to D-SUB jack at the back of this display. And connect the earphone cable from PC earphone output jack to AUDIO input jack near to the D-SUB jack. Setup: Use the key �Digital� Remote Control Transmitter or �MODE� on Front panel controls in key to select source to �VGA�state. Then turn on the PC. � DVI-D: Connect DVI-D 24 Pin signal cable TMDS cable� � from equipment with DVI-D jack to the back of this display. And connect earphone cable from equipment with earphone output jack to AUDIO input jack near the DVI-D jack. Setup: Use the key �Digital� Remote Control Transmitter or �MODE� on Front panel controls in key to select source to �DVI�state. Then turn on the equipment.
8
|
|
|
> |
|
