|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
This is an excellent handbook. We had no information on the appliance until we obtained this and are now able to use the appliance to its full potential. Strongly recommended.
;
Very happy to find this from owners-manual.com and the enclosed spec sheet as well.
Not longer available from Sony.
;
The Owner's manual was very helpful. The WEGA is about 35 years old and needed repair.
Your Website is pretty good und easily to handle.
Thank You
Carl-W. Lohmann
;
Perfect. Very good service and very good scanning quality. All sheets are very legible. Thank's
;
My first manual from Owner-Manuals.com but not the last! I am very satisfied with the easy ordering and promt delivery of a manual I did not find anywhere else.
Install Cabinet into Window
s s
Attach Side Curtains to Window Frame
1. Pull left-hand curtain out until it fits into window channel. Use a ³���" drill bit to drill a starter hole through the hole in the curtain housing and into the lower window sash.
Handle air conditioner gently. Be sure your air conditioner cabinet does not fall out of the opening during installation or removal. The place where the power cord exits the air conditioner should be no more than 4 ft (122 cm) from a grounded 3 prong outlet. Do not block the louvers on the front panel. Do not block the louvers on the outside of the air conditioner.
s
Front View
s s
1. Center empty cabinet in window. Check that lower rail of air conditioner cabinet is behind and against back side of windowsill. Maintain a firm hold on the air conditioner cabinet. Lower window sash to hold cabinet in place. 2. Measure the distance between the right-hand side of the cabinet and the inside of the window channel. 3. Repeat for the left side. Adjust the cabinet until the distance on each side is the same.
Top View
B
A B
A C C
A. Left-hand curtain B. Window channel C. #10 x ³��" round-head screw A. Window sash B. Empty cabinet C. Window channel
2. Insert one of the #10 x ³��" round-head screws through the threaded hole in the top of the curtain.
4. Use a ³���" drill bit to drill 4 starter holes ³��" deep through the 4 holes in the cabinet and into the windowsill. 5. Attach cabinet to windowsill with 4 - #10 x ¹��" pan-head Phillips screws.
A
B
A. #10 x ³��" round-head screw
3. Repeat for right-hand curtain.
A
A
Attach Support Brackets
1. Attach support bracket to the cabinet by aligning the holes in the bracket with the holes in the cabinet.
A. #10 x ��" pan-head Phillips screws B. Windowsill
6. Check that air conditioner cabinet is tilted to the outside so that water will run to the outside.
A
A. Align holes in cabinet with holes in support bracket.
8
|
|
|
> |
|
