|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
The manual was complete and of great quality. Originally a tri-lingual file, I first received only one language. After a note to owners-manuals.com, I quickly received the remaining languages... Great service, definitely worth it.
 ;
Thank you for providing this manual and at low cost.
The Philips scope is of excellent quality, longevity and build and had a couple of faults
when it was passed to me. Having the CCT diagrams is a blessing.
I have fixed the problems and also modded the scope to my requirements.
I have built a 24v Li-Ion pack for portable use from old but good laptop batts.
it is working beautifully and I am well pleased. Keep up the good work Guys.
 ;
manual was very helpful in learning how to propery use my washer. I could not find this manual anywhere else.
 ;
Awesome quality manual. You really saved my bacon with this one. Was looking for some specific information with regards to my "new" vintage VCR that didn't come with the owners manual. This site is truely a goldmine of available manuals. The quality of the scans are top notch.
Thank-you so much for this awesome manual. If you're looking for this Sony SL-HF400 owners manual, this is the one you NEED to buy. Definitely worth the money.
 ;
The manual was made available promptly. I is a clean scan of the original. I had no problem downloading it. The scan was well centered and cleanly formatted. It is as good a product as can be had without being the original document.
16. Fasten cabinet to window sill. Lower window sash firmly onto cabinet. Place a carpenter�s level inside the cabinet and make sure cabinet is level side-to-side. Then drill starter holes into the cabinet base and the window sill. Use roundhead wood screws (H) to fasten cabinet to window sill, but do not tighten the screws. 17. Make sure cabinet has proper outward slope. Place carpenter�s level in the right side of the cabinet. There should be a l/2 bubble tilt (W [6 mm]per foot [30.5 cm]) toward the outside. Repeat for left side of cabinet. The tilt to the outside is needed for proper drainage. 18. Attach 2%� (63.5 mm) seal strip (I) to inside of cabinet. Make sure the seal strip is flush with the front edge of the cabinet. This seal strip provides a seal between the air conditioner base and the cabinet.
19. Assemble the outside support. Attach the vertical supports (J) to the angled supports (K). Use the round-head bolts (L), flat washers (M), lock washers (N) and the nuts (0) for attachments. Then attach these supports to the bottom of the cabinet, but DO NOT tighten the bolts at this time. Attach the wall rail (P) to the bottom of the supports and slide the support assembly toward the house until the wall rail presses firmly against the wall. Check that you have the % bubble tilt to the outside. This is needed for proper drainage. Now tighten all bolts. Tighten angled support bolts last so wall rail fits tightly against the house. NOTE: If your house is constructed of materials that could be damaged by the wall rail, fasten a board or other protective material to the wall rail so that it is between the wall rail and the house.
continued
on next page 11
|
|
 |
> |
|