WHIRLPOOL ACM 844 WH
Owner's Manual

PROGRAMMER WITH NUMERICAL CLOCK
FUNCTIONS Length of cooking time, end of cooking, manual position, clock, timer, time programmable up to 23 hours and 59 minutes. DISPLAY Fluorescent 4 digit 7 segment display to show the time and cooking time. Use the + and � buttons to select the end of cooking time required. The AUTO and length of cooking time symbols stay on. The relay contacts switch on. When the end of cooking time coincides with the time set the relay and the length of cooking symbol switch off. At the end of cooking time the AUTO symbol flashes, the beep sounds and the length of cooking and the relay switch off. AUTOMATIC OPERATION WITH LENGTH AND END OF COOKING Press the length of cooking time button and use the + and � buttons to select the length of cooking time required. The AUTO and length of cooking time symbols stay on. The relays switch on. Press the end of cooking button. The display shows the nearest end of cooking time. Use the + button to select the end of cooking time required. The relay and the length of cooking time symbol switch off. The symbol lights up again when the time coincides with the start cooking time. At the end of cooking time the AUTO symbol flashes, the beep sounds and the length of cooking and the relay switch off. TIMER Press the timer button and use the + or � button to select the cooking time required. The bell symbol lights up when the timer is operating. At the end of the programmed time the beep sounds and the bell symbol goes out. BEEP The beep sounds at the end of a programming or a timer function and lasts for 15 minutes. To stop it press any function button. BEGIN PROGRAM AND CHECK The program starts about 4 seconds after programming. The program can be checked at any time by pressing the corresponding button. PROGRAMMING ERROR There is a programming error if the time indicated by the clock is between the start cooking time and the end of cooking time. A beep sounds immediately and the AUTO symbol flashes intermittently. The programming error can be corrected by varying the length of cooking or the end of cooking time. If there is a programming error the relays are switched off. CANCELLING A PROGRAM A program can be cancelled by pressing the length of cooking time button and the � button until the display shows 00 00. At the end of a selected program it is automatically cancelled.

The corresponding symbol lights up to show the functions selected. Programming is by touching the button of the function required. Release the button and set the time using the + and � buttons in 5 second steps.

+ AND � BUTTON
Push the + and � buttons to increase or decrease the time. The speed with which the time changes depends on how hard the button is pressed. PROGRAMMING THE TIME Pressing the length of cooking and end of cooking time buttons simultaneously, set the time required with the + and � buttons. This operation cancels previously saved programs and the contacts are switched off. MANUAL OPERATION On pressing the manual button, the relay contacts are switched on, the auto symbol goes out and the pan symbol lights up. Manual operation is only possible at the end of automatic programming or after cancelling it. AUTOMATIC OPERATION On pressing the length of cooking or end of cooking buttons the programmer automatically switches from manual mode to automatic mode. SEMI-AUTOMATIC OPERATION WITH LENGTH OF COOKING TIME Press the length of cooking time and set the time required using the + or � button. The AUTO symbol and the length of cooking symbol stay on. The relay switches on immediately. When the end of cooking time coincides with the time set the relay and the length of cooking symbol switch off, the beep sounds and the AUTO symbol flashes. SEMI-AUTOMATIC OPERATION WITH END OF COOKING Press the end of cooking button. The display shows the current time.

PL

GB

Printed in Italy 07/00