|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Absolutely perfect! I've been trying to understand how to use all or at least some of the features of the receiver and especially the remote.
;
Copy of genuine owners/operators manual, very useful
;
The manual was a perfect match and was exactly what I was looking for. I'm very satisfied with my purchase.
;
Thank you for having the manual I needed for an older model Aiwa stero I had found on Ebay --- I wanted the Aiwa because I had tapes and cd's but I did not have a manual as to how to operate the system... I found what I needed and it has enabled me to set the system up for my enjoyment.
;
I wished detailed information of the JBL S310 and here I found it! Very happy with the service from this site!
6
. Measure and cut filler
size. First, measure the distance from inside one window channel to the inside of the other channel and subtract l/4�. Now subtract the width of the air conditioner and divide by 2. This will give you the width to cut each filler board. Be sure to cut the filler boards on the sides opposite the holes. Because the filler boards will be equal in width, they will automatically center your air conditioner in your window.
boards to proper
8
a Place air conditioner
in window by turning unit to one side to get one filler board into window channel (see Figure 36). Now maneuver other filler board into window channel. Reaching through window opening, push filler boards from outside as far toward you as they will go. Be sure to use the foam blocks that are provided. CAUTION: BE SURE UNIT DOES NOT FALL OUT OF WINDOW.
Figure 34
MEASURE DISTANCE FROM INSIDE ONE WINDOW CHANNEL TO INSIDE OF THE OTHER AND SUBTRACT 114�
Figure 36
THE FOAM BLOCKS PROVIDED ARE TO HOLD FILLER BOARD TIGHT AGAINST WINDOW CHANNEL. CUT BLOCKS 114 INCH WIDER THAN CHANNEL AND WEDGE INTO PLACE.
(
i
7 0 Apply
seal strips and attach filler boards. Determine which will be your left and right filler boards. The holes on each board should align with the holes in the side mounting angles. Each filler board should also extend about l/2� above the top edge of the air conditioner cabinet, Now apply 3/8�-wide seal strips on the roomside of each filler board as shown in Figure 35 (i.e. along with bottom edge and window channel edge). Also place a seal strip along the top outside edge of each filler board. Now attach the filler boards to the side mounting angles with the sheet metal screws. Tighten the screws only loosely so the filler boards can be moved back and forth.
9
l
Place side mounting
slides into top mounting
channel. Extend the mounting slides outward into the window channels on both sides (see Figure 37). Pull the air conditioner toward you to position the side mounting slides as far forward in the window channels as possible. Now mark and make a 3/32� pilot hole for each wood screw used to secure the slides in the window channels. CAUTION: BE SURE UNIT DOES NOT FALL OUT OF WINDOW.
Figure 35
1
13
BOARD
|
|
|
> |
|
