I purchased the unit from a private party and the original owners manual was not available. Having the ability to download it was extremely helpful and clarified operating the equipment immensely. This is a complicated unit and without the manual I would not have been able to maximize it's potential. Thank you.
Being a user of older radios of many kinds, preferring them over more modern rigs, this manual was invaluable in the programming of my two. I now know for certain what the assorted buttons functions are, and am very grateful to have found this excellent site. Many thanks for your assistance, Tony.
5 star quality on these downloadable manuals. Easy to read and all the information is there. A must when doing a custom install or needing to service your precious old school electronics.
Text excerpt from page 13 (click to view)
2. Using 2 - #10 - 12 x 1¹��" slot-head wood screws, secure the tray-frame assembly to the wall opening.
3. With tray center pushed away from the windowsill, place a level on the angled edge on top of the tray side. Be sure level is against notch on tray side.
Left Side
A B
A
A. #10 - 12 x 1¹��" slot-head wood screw
A. Angled edge on top of the tray side B. Notch
Right Side
4. Adjust SMART-MOUNT® tray until bubble indicates the angled edge on top of the tray side is level. IMPORTANT: The tray must slope downward slightly toward the outside to provide proper drainage for the air conditioner.
A
B A
A. #10 - 12 x 1¹��" slot-head wood screw
NOTE: If the exterior of building can be damaged by support legs, place a board between the wall and support legs.
A. Bubble indicates the angled edge on top of the tray side is level. B. Place level on angled edge against notch on tray side.
5. Tighten the hex nut just enough to hold tray center in place. 6. Repeat with other side. 7. Tighten hex nuts securely with ����" wrench.
Position the Air Conditioner Through the Wall
s s
Handle air conditioner gently. Be sure your air conditioner does not fall out of the opening during installation or removal. Do not block the louvers on the front panel. Do not block the louvers on the outside of the air conditioner.
s s
WARNING
Excessive Weight Hazard Use two or more people to move and install air conditioner. Failure to do so can result in back or other injury.
1. Place the air conditioner in the SMART-MOUNT® tray. Check that feet on bottom of air conditioner are resting on the ³��" (1.9 cm) x 2" (5 cm) wood strip at the bottom of the wall opening and the top channel rests against the top of the wall opening.
B A
A. SMART-MOUNT® tray B. Feet on bottom of air conditioner resting on wood strip
