|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Whilst this is a photo copy, and some of the pages are a little askew, it was all readable and intact. A real bonus finding an old manual for a classic piece of kit that no other site had.
Great stuff.
;
excellent quality, contains circuits and scan quality, 110 pages
;
It was easy done, and I got exactly what I was looking for.
;
The manuel was exactly what I needed and I received it promptly. Thanks
;
Thanks to Owner-Manuals.com! This manual was exactly what I needed. As Amana was purchased by Maytag and later by Whirlpool, there was no way to receive it from their websites. I was lucky to find this resource.
Install Cabinet into Window
s s
Attach Side Curtains to Window Frame
1. Pull left-hand curtain out until it fits into window channel. Use a ³���" drill bit to drill a starter hole through the hole in the curtain housing and into the lower window sash.
Handle air conditioner gently. Be sure your air conditioner cabinet does not fall out of the opening during installation or removal. The place where the power cord exits the air conditioner should be no more than 4 ft (122 cm) from a grounded 3 prong outlet. Do not block the louvers on the front panel. Do not block the louvers on the outside of the air conditioner.
s
Front View
s s
1. Center empty cabinet in window. Check that lower rail of air conditioner cabinet is behind and against back side of windowsill. Maintain a firm hold on the air conditioner cabinet. Lower window sash to hold cabinet in place. 2. Measure the distance between the right-hand side of the cabinet and the inside of the window channel. 3. Repeat for the left side. Adjust the cabinet until the distance on each side is the same.
Top View
B
A B
A C C
A. Left-hand curtain B. Window channel C. #10 x ³��" round-head screw A. Window sash B. Empty cabinet C. Window channel
2. Insert one of the #10 x ³��" round-head screws through the threaded hole in the top of the curtain.
4. Use a ³���" drill bit to drill 4 starter holes ³��" deep through the 4 holes in the cabinet and into the windowsill. 5. Attach cabinet to windowsill with 4 - #10 x ¹��" pan-head Phillips screws.
A
B
A. #10 x ³��" round-head screw
3. Repeat for right-hand curtain.
A
A
Attach Support Brackets
1. Attach support bracket to the cabinet by aligning the holes in the bracket with the holes in the cabinet.
A. #10 x ��" pan-head Phillips screws B. Windowsill
6. Check that air conditioner cabinet is tilted to the outside so that water will run to the outside.
A
A. Align holes in cabinet with holes in support bracket.
8
|
|
|
> |
|
