|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
The manual was made available promptly. I is a clean scan of the original. I had no problem downloading it. The scan was well centered and cleanly formatted. It is as good a product as can be had without being the original document.
 ;
Received downlink in less then 8 hours, Item was in good copy condition, and told me how to program the clock timer. The price was very resonable, and the process was very automated and was GREAT to work with.
;
Fast service, document is OK. Thanks! Searched for it long time.
;
I was very pleased with the manual I got for my amateur (ham) radio. Without it I could not figure out how to input and/or change the P/L setting on my radio. It drove me nuts as the radio was essentially useless. That all changed when my manual came. Then it took only minutes and I was done. Now my radio works fine. This is an exceptionally good resource as it's a very easy and user friendly download. Thank you very much! Dziękujemy za!
;
It answered my question, which was how to load the paper. I did notice that the very end of the manual was not visible.
SWITCHING CHANNELS
With either the CH1 or CH2 LED lit, press the CH switch. The channel will change each time you press the button, and the program stored in each channel will be recalled. (The physical settings of the top panel selector knobs and control knobs are ignored at this time.)
HINT: If the optional VFS2 dual foot switch is connected to the rear panel, you can use it to switch programs. For details, refer to �Using the VSF2 dual foot switch� (page 16). HINT: If you want to bypass the effect, press the BYPASS button. If the BYPASS LED is lit, there is no effect. To turn the effect on, press the BYPASS button once to turn off the LED. The AD15VT, AD30VT,AD50VT & AD100VT remember the bypass setting even if you switch modes or programs, or turn off the power.
MANUAL MODE
When the AD15VT, AD30VT, AD50VT or AD100VT is in Manual mode, it works just like a non-programmable guitar amp. In other words, the positions of all top panel selectors and knobs (except for the EDIT 1 knob) indicate exactly what you�re hearing.
GETTING TO MANUAL MODE
If the MANUAL LED is dark, you�re not in Manual mode. Press the MANUAL button; the MANUAL LED will light, and you�ll be in Manual mode.
NOTE: If the CH1 or CH2 LED is blinking (i.e., when you�re in the middle of selecting a writing-destination for the program), the MANUAL LED won�t light when you press the MANUAL button the �rst time. In this case, simply press the MANUAL button once again. NOTE: In Manual mode when you edit parameters that aren�t de�ned by a knob setting (i.e., effect parameters or noise reduction settings), those settings are saved automatically, and will be recalled the next time you enter Manual mode. However if the EFFECTS selector is at a different position than it was when you were last in Manual mode, the default settings for that effect type will be loaded. HINT: If you want to bypass the effect, press the BYPASS button. If the BYPASS LED is lit, there is no effect. To turn the effect on, press the BYPASS button once to turn off the LED. The AD15VT, AD30VT,AD50VT & AD100VT remember the bypass setting even if you switch modes, programs, or turn off the power.Creating and storing your own program
11
|
|
|
> |
|
