|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
This manual is accurate and of high quality. It is only volume 2 of the service manual. This is schematic, parts lists, and exploded mechanical drawings. The theory of operation and the diss-assembly instructions are in volume 1. The unit can be tricky to dis-assemble portions of so the volume 1 manual can be important. The product description of the manual is accurate but it does not say anything about volume 1 and the image of the front page does clearly say Volume 2.
 ;
Wellll again thank you very much fast and effective. Clear and well done for such an old TV!!!!
;
It has all the information you will need to fix it. The main circuit diagram is only A4 but being a PDF, you can print it to any size - I did it on two sheets of A3 and it didnt lose any detail - just made it readable when pinned up above the bench. I've found the fault, just need to buy some obscure bits to get it going again!
I cant fault the process, I paid for the manual in the morning and it was ready to download by lunch time.
;
Very good copy in a 54 pages PDF archive. This is my sixth purchase here. :)
;
Another excellent buy! File too clear and explanatory.
CHAPTER 5 TROUBLESHOOTING
4) Open the DADF slowly, and measure the copy paper stop position 4; then, close the DADF.
Copyboard glass
�
Push Switch and Shift
Push switch SW1 SW2 Direction of shift Rear Front
Table 5-103
4
Copy paper
Note: Holding down the push switch will not cause more than a single shift.
Standard:
4
= 11.0 ±1 mm
DADF
Figure 5-115 5) To adjust the original leading edge stop position, use the push switches (SW1 and SW2) on the DADF controller PCB. Each press on the push switch will shift the original stop position by 0.34 mm. When the correct position is attained, press the push switch (SW3) once. The copy paper will be discharged and the new setting will be stored.
Copy paper
Leading edge Trailing edge
Copyboard glass
Figure 5-117 <EX.> Suppose that the copy paper stop position L4 is 10 mm from the edge of the copyboard glass when the push switch (SW3) on the DADF control PCB has been pushed once to stop the copy paper on the copyboard glass and the DADF has been opened. Close the DADF slowly without removing the copy paper, To shift the copy paper stop position toward the rear by 1.6 mm, 1.6 mm/0.34 (adjustment pitch) = 4.70 the push switch (SW1) should be pressed five times. Press the push switch (SW1) five times, and press the push switch (SW3) on the DADF controller PCB once so that the copy paper will be discharged and the new setting will be stored in memory.
1
2
1
4
12
1
10
1
9
J15
7
J5 CB1 J1 J2 J3 J14 J8
13 14
1 1 2 1
2
1 8
J13 J6
J10
1
3 1 2
J7
DSW1 SW1 SW3 SW2 TP1
B12 B1 2 A1 1
J11
1 3
J9
A12
J12
Figure 5-116
COPYRIGHT © 1999 CANON INC.
CANON DADF-C1 REV.0 JAN. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)
5-5
|
|
|
> |
|
