|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Very good quality, prompt response. This website has reasonable prices and wide range of manuals that are hard to find.
;
The document was usefull, and it was exactly what I was looking for.
;
OK?..manual is complet and helpfull... for repairing such a old and rare boombox like JVC PCM it is necessary...
;
Super Anleitung. Ordentliche Auflösung. Das ganze noch in Deutsch wäre zu schön. Alle Datenblätter sind sauber Kopiert und alle Leitungswege sind sauber ausgeführt
;
Thanks God for the internet and thanks for the service like this - proffessional solution on time.
SERVICE
Technical data
Water pressure Inlet pressure Spray pump pressure Rotations Spray pump motor Drain pump motor Spray arm lower Spray arm upper
Whirlpool Europe Customer Service
ADG 6556 IXM 8542 556 10740
14.02.2002 / Page 3 Doc. No: 4812 718 17313
Electrical base data 0.3 - 10 0.3 bar bar Voltage Frequency Total power Fuse 220/ 230 50 2.0 - 2.2 10 V Hz kW A
2800 3000 30 - 40 30 - 40
RPM RPM RPM RPM
Spray pump motor alternating spray system Voltage Power consumption HI HA Capacitor Drain pump motor Voltage Power consumption Resistance 220/ 240 V 30 W 146 � 220/ 240 125 79 60 4 V W � � µF
Spray arms, turning rhythm at alternating spray system Turning starts every time with the upper spray arm Pre wash Lower arm ~3min, Upper arm ~1min Main wash Lower arm ~3min, Upper arm ~5min Intermediate rinse Lower arm ~2min, Upper arm ~2min Final rinse Lower arm ~2min, Upper arm ~2min Service Test program Lower arm ~30sec, Upper arm ~30sec Remark: When switching of the main switch or interrupt the mains during the Test Program runs, then the alternating of the spray arms change in the test program to the rhythm of main wash 5/3 min. Important: To leaf the Test program is possible by made a break by customer (pushing the start button for 1.5 sec.) After �nishing the test program (End LED shines and/or Start LED goes of) must the appliance be switched off. If this will not be done, then the next normal wash will be made with the frequency of the Service Test Program ~30/30sec. Flow rates/ Inlet volume Flow meter (at 0.3 bar = quantity 1.1 l/min) Spray pump Drain pump Pump height max. Inlet valve Spray arm lower Sprayarm upper Shower top 208 45 - 65 16 1.1 4 ~ 33 ~ 27 ~8 lmp/l l/min l/min m l/min l/min l/min l/min
Heating 1 Element system Voltage Power consumption Resistance Heating speed Temperature on surface Safety thermostat self reset (Temperature of water) Fuse Potentiometer Points of meassurement: 1(black) to 2 (middle) Position 0 Position 1 Position 2 Position 3 Position 4 Position 5 Position 6 Water valves Single electric inlet valve Voltage Frequency Resistance 220/ 240 V 50/ 60 Hz 3.76 k� 0.0 0.5 1.0 1.4 1.8 2.3 2.6 k� k� k� k� k� k� k� 220/ 230 1.87/ 2.04 24.5 ~ 2.0 ~ 115 V kW � �C/min �C
~ 85 206
�C �C
|
|
|
> |
|
